Hello! After many years watching my dad’s TT sitting, I’m finally hoping to get it back on the road again. To keep it short, we’ve had it for 15 years, no maintenance, oil change done 2 times, engine began to misfire and turbos didn’t want to boost. After diagnosing I found out cylinder 2 and 4 had low compression due to seized oil rings from it sitting. I came across this crazy deal of a torn apart 40k miles automatic TT engine with everything needed to piece back together. Along with that he provided full oem gasket kit, greddy boost controller, 550cc injectors, czp tune, down pipes, and bigger intercoolers. I went ahead and ordered arp head studs, 2.5 inch intercooler piping and a bunch of maintenance parts like water pump, sensors, radiator ect. I wanted to see if anyone has any tips/recommendations for my rebuild. This is my first time building an engine and have been doing so much research. I’m not planning anything big just simple bolt ons. With the purchase, the seller provided a box of 4 turbos torn apart 2 automatic turbos off the same car the motor came out of and 2 manual turbos with unknown miles. Upon doing research I’ve heard the manual turbos are generally better since the housing is bigger. My question is since it’s all torn apart would I be able to Frankenstein the turbos? Use the automatic components onto the manual housing? I’ve also heard that it’s needed to clock the turbos and understand what side is left and what is right. How can i determine that? Are stock oil lines worth keeping or are the braided lines better? Is hicas also worth deleting? I’ve heard so much mixed opinions on it. I’m also doing aiv, cc, egr, and coolant plenum deletes. Any information is greatly appreciated. Thank you