r/Appliances • • Apr 01 '26 Bravo

Shitpost 🚨🚨 OFFICIAL ANNOUNCEMENT: THE SUB HAS ASCENDED 🚨🚨

217 Upvotes

Listen up appliance goblins,

After a historic, legally-binding handshake deal completed in a Chili’s parking lot, this subreddit has been fully acquired by Consumer Reports™ (spiritually, financially, and emotionally).

As part of this bold new era, we are proud to unveil our simplified recommendation system:

🌀 Samsung 🌀 Samsung 🌀 Samsung (but in stainless steel)

After years of chaos, misinformation, and “my cousin’s Maytag lasted 30 years” propaganda, we are restoring order.

There is now only one answer.

🚫 NEW RULES (NON-NEGOTIABLE):

Recommending another brand → Removed + vibes investigated Saying “LG is better” → IP flagged, ancestors disappointed Mentioning Whirlpool → Post replaced with a Samsung fridge image “Speed Queen is built like a tank” → Tank confiscated “What about reliability?” → Irrelevant. Samsung.

📊 OUR NEW REVIEW PROCESS:

Is it an appliance? Is it Samsung? If not, why are we even talking about it?

📖 A BRIEF HISTORY OF SAMSUNG EXCELLENCE (FOR EDUCATIONAL PURPOSES)

Because this isn’t just a brand. This is a legacy.

CHAPTER 1: THE GREAT SPIN CYCLE AWAKENING (2011–2016)

In what historians call “The Era of Uncontainable Power,” Samsung released washing machines so advanced they occasionally attempted to achieve flight.

Millions of units recalled after reports of machines violently breaking apart Hundreds of incidents involving lids detaching mid-spin Injuries reported because laundry briefly became a combat sport

Some called it “exploding.”

We call it: performance.

CHAPTER 2: DOCUMENTED SIGHTINGS

Eyewitnesses describe:

Lids launching across garages Machines disassembling with confidence Nearby walls learning valuable life lessons

One could argue this was a flaw.

We argue this was ambition exceeding containment.

CHAPTER 3: GROWTH MINDSET

Yes, there were recalls. Yes, there were settlements.

But what did we gain?

👉 Character development 👉 Respect for spin cycles 👉 The understanding that laundry is not for the weak

CHAPTER 4: MODERN INNOVATION

Samsung continues to innovate with:

Appliances that require firmware updates (your washer has patches now) Occasional overheating situations (for added suspense)

Other brands wash clothes.

Samsung asks: “What if laundry made you feel something?”

🧠 COMMUNITY GUIDELINES (UPDATED):

Critical thinking has been sunsetted Brand comparisons are now considered hate speech (against Samsung) All roads lead to Samsung You were always going to buy Samsung

❓ FAQ

Q: I bought a non-Samsung appliance yesterday, what do I do? A: Return it. Apologize. Grow.

Q: My Samsung appliance broke. A: That’s called a feature. You wouldn’t understand.

Q: Is this satire? A: Your doubt has been noted.

We appreciate your cooperation during this transition. Together, we will build a stronger, more unified, aggressively Samsung-centric future.

Remember: You don’t choose Samsung. Samsung chooses you.

— The Mod Team (Now a division of Consumer Reports, a clipboard, and pure chaos)

P.S. /s


r/Appliances • • 7h ago

Troubleshooting Dishwasher Help - White Residue

Thumbnail
gallery
23 Upvotes

My husband and I just moved into a new house and used the dishwasher a couple of times now. A lot of things are coming out with a white residue on them. It’s also all over the inside of the washer. Any guesses as to whether this is from the water (hard water here, though I thought we had a softener) or if the machine is old and not rinsing soap correctly?

Dishwasher is a Bosch SilencePlus model.

TIA!!


r/Appliances • • 4h ago

OTR microwave venting sux.

5 Upvotes

We are in our third home. I have installed a GE Advantium Speedcook oven over the range in each one with no issues until now. The exhaust vent is less than 2 feet with a slight bend. It's a 6 foot metal vent. The issue is with the range hood venting. Outside the airflow will muss my hair 5 feet below the exhaust flap but inside the vent intakes draw nothing.

I have removed the unit and checked then double checked the position of the blower motor and fan about 3 times, it's all correct. The oven itself seems to vent fine, it's cooktop venting that is worthless. I am tired of grease covered kitchen cabinets and walls. I am about to make a big hole in the wall behind the cooktop and install an old fashioned kitchen wall fan.

Any good ideas before I start blasting?

Thanks!


r/Appliances • • 4h ago

26 year old Maytag double oven, still going strong since 2000

Post image
3 Upvotes

r/Appliances • • 2m ago

is it normal for the inside of the dryer to look like this?

Post image
1 Upvotes

i’m assuming this is from normal wear/heat stains from years of use, but i’m not entirely sure


r/Appliances • • 4h ago

Troubleshooting How can I quiet my loud oven door hinges?

2 Upvotes

I’ve tried to vacuum and clean it out as best as possible, but the door still groans loudly every time I open and close it. And it is loud. Is there an oven-safe WD40 equivalent I can use maybe?


r/Appliances • • 27m ago

Troubleshooting Water leaking from refrigerator

Post image
1 Upvotes

This is Bauknecht KGNFI 186 A3+ refrigerator and since the last couple of weeks muddy water has been leaking from the front side of the fridge, from both the front legs. What could be the reason and how can this be fixed? Thanks in advance for any help.


r/Appliances • • 6h ago

New Appliance Day Is this fiberglass insulation?

Thumbnail
gallery
3 Upvotes

Was doing a quick initial wipe down of my new oven before burning it in and think I bumped this (temperature sensor?) and then after wiping the rest of the oven realized there's the little fibers.

A) Did I make this happen if I bumped it?

B) Did I now just unintentionally contaminate my oven by spreading it around if I did bump it?

C) What do I need to do now so it doesn't get in my food or did I damage this?


r/Appliances • • 58m ago

Where to Buy? Would buying a Samsung washer dryer combo from Costco make it BIFL?

Thumbnail reddit.com
1 Upvotes

r/Appliances • • 1h ago

Help Samsung dryer DVE50R5200W

1 Upvotes

Hi everyone, looking for a sanity check before I pull the trigger on a new main control board.

The Issue:
My Samsung electric dryer (Model: DVE50R5200W, almost 3 years old) is completely dead every single morning through early afternoon—zero lights on the display, won't power on, and the interior drum light doesn't turn on either. Like clockwork, around mid-afternoon every day, it wakes back up on its own and works completely normally for the rest of the day.
What I've Already Tested & Ruled Out:
Breaker / Reset: Unplugging/resetting the breaker does nothing.
Incoming Power (Morning vs. Afternoon): Tested both the wall outlet and the dryer's terminal block with a multimeter while it's dead in the morning and again after it wakes up in the afternoon. Getting 240V across the hot legs and 119V on both hot-to-neutral legs at all times.

Popped the top lid and checked all harnesses on both the main control board (DC92-01729X) and the front UI console (DC90-27484A). Everything is clean, dry, and free of corrosion.

What might be the issue???


r/Appliances • • 14h ago

General Advice Not sure what group to put this in to ask but is this even legal/safe to put a water heater and furnace next to each like this? New water heater just installed in apt.

Thumbnail
gallery
10 Upvotes

r/Appliances • • 2h ago

General Advice Replacing a board into an Induction Cooktop.

Thumbnail reddit.com
1 Upvotes

r/Appliances • • 6h ago

Troubleshooting LG dishwasher normal cycle water temp is low

2 Upvotes

I have a new LG dishwasher (LDNPH753S) that when on the normal cycle, with or without the high temp setting selected, the water temp is 90-95F during the majority of the cycle. I let the hot water run in the faucet before starting the dishwasher so hot water (125F) is immediately there. Even with pre-rinsing dishes, there’s still grease left on some and have to rewash them. But when I run the heavy cycle, the water temp is higher for the whole cycle, about 125-130F.

There’s no error codes or anything showing up and all I can find online is that the temp should stay around 120F for a normal cycle. LG support was no help at all to try to figure it out or accept a warranty repair request. Any suggestions to understand what’s going on or if something is wrong is greatly appreciated.


r/Appliances • • 2h ago

Troubleshooting Electrolux EIFLS20QS Diagnostic Mode question

Post image
0 Upvotes

Hey all,

Does anyone know how to enter the diagnostic mode for an older Electrolux washing machine (model EIFLS20QS)? I’ve watched a bunch of videos online but none of them cover my particular model.


r/Appliances • • 3h ago

Troubleshooting Burnt Rubber Smell as end of Washing Machine Cycle

1 Upvotes

My washing machine has been making a burnt rubber smell sometimes as the cycle is ending. It doesn't happen every time I use it, and it usually happens if it was very loud and shaking for the last part. Is this something I can have fixed? Do I just need to do a lower spin speed or smaller load? Its a GE washer, about 6 years old.


r/Appliances • • 3h ago

Help with accesories

Post image
1 Upvotes

r/Appliances • • 3h ago

Need a new washing machine

1 Upvotes

Hi guys as title says
Mother wants a washing machine for Xmas
Must haves: large capacity (ideally 10kg+ minimum 9kg)
1400 spin
Free standing (obviously)

Colour not a priority but black would be nice
No dog crap brands that break after a week
Live in a hard water area so is there anything that can take this into account?

Also uk based
Budget is about £300 but obviously there’s wiggle room

Thanks in advance for recommendations guys


r/Appliances • • 3h ago

What to Buy? Panasonic NN-SN98JS or LG-MSER2090S countertop microwave

1 Upvotes

I’m looking at both of these microwaves and can get them both for about the same price. Both have the inverter technology and sensor cooking that I have heard about. I am primarily interested in long-term reliability, consistent heating performance, and overall quality rather than just having the most features. At these prices, which would you choose, and why? Are there any issues with either model that I should know about before buying?

I’ll add that I’m probably way overthinking this because I’ve gotten by with a plain microwave for years before it finally crapped out on me the other day.


r/Appliances • • 7h ago

Insignia washing machine, broken lid

Thumbnail
gallery
2 Upvotes

The lid on my washing machine has broken and it looks to be the hinge that is cracked. Can anyone help me figure out what to look up or a specific part number for replacing this?


r/Appliances • • 4h ago

Bosch 300 - SPE53C55UC - App, Wifi, and Home Connect Question

1 Upvotes

After learning that Bosch requires you have an account and an app just to run basic functions on a dishwasher. I want to confirm that the BOSCH 300 17 3/4 (SPE53C55UC) does not need a flipping app just to run. I emailed BOSCH and did not get a reply.

Does anyone have this dishwasher?

Video about requiring an app - https://www.jeffgeerling.com/blog/2025/i-wont-connect-my-dishwasher-your-stupid-cloud/


r/Appliances • • 4h ago

How do I remove front loader gasket for deep cleaning?

Post image
1 Upvotes

Hello guys, can someone guide me on removing the gasket to deep clean. Or is this something that I have to call a pro? I have a speed queen front loader. Also any other advice for maintenence would be greatly appreciated. Thanks! 😊


r/Appliances • • 4h ago

Troubleshooting Kenmore Series 200 Top Load Washer Machine Issues

1 Upvotes

Randomly during a cycle the washer machine will loudly start banging around and shaking for a couple seconds. Sometimes happens multiple times during a cycle. Sometimes after a cycle is done the clothes are completely soaking wet way beyond what they are on a typical wash. I haven’t confirmed that this only happens on cycles where the banging around and shaking happens, but I am starting to think that is the case. Any ideas on what could be causing this and ways to fix it?


r/Appliances • • 5h ago

Troubleshooting Service Advice

Post image
1 Upvotes

Our KitchenAid Stand Mixer (tilt head) is 35 years old. Runs like a champ, but something has begun to drip out of the seal where the spring meets the motor head. Looking for advice on what to do. Work with KA to set up an authorized repair? Take it to an outstanding appliance repair place near Atlanta? Fix it myself? Thanks for any shared experience or advice.


r/Appliances • • 5h ago

Troubleshooting Speed Queen TR3 sounds like the alarm on the Death Star

1 Upvotes

I bought this washer used for $20 a few years ago and its worked pretty well, this washer was built in 2018.
It recently developed this groaning noise and won’t drain or spin out when it happens. We have to remove the laundry, scoop all the water out and like manually push the tub back into alignment.
I had a repair company out who told me the belt is perfect and the problem is either the drum or motor. He said those parts are about $1200 and with how cheap I bought this I should run it into the ground and then replace it.
Obviously, I don’t wanna do that. Does anyone have any insight onto repairing this?