r/Yamaha • u/TalismanJake • 11h ago
The 50th Anniversary Raptor 700 😎
r/Yamaha • u/andias8825 • 1d ago
Feel free to remove if not within rules of the sub, just wanted to share
r/Yamaha • u/majedevz • 22h ago
Yello fellow riders, here for a rant.
I seriously love riding, and I have a reason for that.
I fell in love with riding during the worst time of my life. Everything was collapsing; my whole life was. During that time, I got on a bike, and oh boy, I found peace. A few months later, I got my own bike.
It was an experience I'll forever be grateful for. Imagine a building collapsing, and imagine the sound of the rubble; my life was collapsing, and the problems were coming from each side. I wasn't able to find an escape, but when I put on my helmet, it was like someone gave me a remote control with one button: mute. I can't stop/pause the collapse, but I can, for some time, silence the sound of the rubble.
I miss riding. I had to stop because I was abroad, but currently I can't due to my parents (I'm in my mid-20s, but my parents don't want me to ride, so I'm being patient and hoping that somehow, someway, someday, they will allow me.
I really miss riding, guys. I lost almost every single one of my buddies in those few years. Riding was there.
r/Yamaha • u/Acrobatic_Chef_7205 • 1d ago
Did some work on it, replacing the headlight bulbs to LED bulbs & polish the headlight housing, upgrade the trailer hitch, and rear light to LED clear smoke, and miscellaneous maintenance, checked the engine oil, which was 2 quarts low, and added more to the rear differential, also low. This is just the start as it was not in good condition, stay tuned
r/Yamaha • u/Naive-Ad-732 • 3d ago
Hey, All:
This is my 2023 Yamaha R3: little over 28k miles; I'm a truck driver and I have to keep her outside so don't critique me to hard. Just got her back from installing my front turn signals and my fender eliminator with signals. Little beast of a 300.
r/Yamaha • u/vansegen1313 • 2d ago
wanted to see what i actually do in corners instead of guessing, so i made an app for it. phone goes on the bars or tank, you ride, and afterwards you get every corner on the map with lean, speed in and out and when you got back on the gas, plus every braking zone and whether you trail braked.
you can replay a corner with a little bike leaning like you did, compare the same corner across rides, and see where on the tire you were riding, front and rear.
so far i've only tested it on my mt-07, on the street. if you ride an r7, tracer, tenere or anything else, put your tire sizes in under my bike, it makes the lean more accurate. i'd really like to hear if the numbers look right on other yamahas.
free, no ads, no account needed, rides stay on your phone. iphone only for now.
Hi everyone,
I have a 2008 Yamaha Raptor 250 (YFM250RX) and I’m trying to diagnose a running issue.
The symptoms:
Every time I install a new spark plug, it becomes covered in thick, dry black carbon soot after just 1–3 minutes of running.
The exhaust produces black smoke, especially when I give it throttle.
While riding, the ATV eventually starts bogging down, occasionally backfires once, and then stalls.
Sometimes it starts perfectly, sometimes it has trouble starting.
Compression readings were approximately 6 bar cold and 6.5 bar hot, with the throttle fully open.
The factory service manual specifies a minimum compression of 9.2 kg/cm².
I’ve recently removed and cleaned the carburetor twice, but the problem remains.
I suspect the carburetor is running too rich or overflowing, possibly due to a faulty float needle, incorrect float height, or a choke/enrichment plunger that isn’t closing properly.
Interestingly, after opening the air filter housing, the ATV started much more easily.
My questions:
Would you start with the carburetor (float level, needle valve, choke)?
Could weak ignition or incorrect ignition timing cause this much carbon buildup and black smoke?
Could low compression contribute to incomplete combustion and plug fouling?
Is there anything specific to the 2008 Raptor 250 that I should inspect?
I’m happy to work on it myself and would appreciate advice from anyone familiar with this model.
Thanks!
r/Yamaha • u/Argonaut_Not • 3d ago
Recently stumbled across what appears to be a loose vacuum line that I can not find the connection for. Any other Vision owners know where it goes?
r/Yamaha
•
u/Motodrew
•
5d ago
I had this 1975 Yamaha GT80 as a youngster. My Dad found it in the family’s barn that we sold it to decades ago. I spent the last few years sourcing parts and a donor bike to bring it back to its original glory!
r/Yamaha • u/GlitteringSnow2137 • 5d ago
Video can’t do it justice. Don’t think I’ll ever get tired of this bike.
r/Yamaha • u/Money-Freedom7763 • 4d ago
I am looking for a Yamaha FZ-S V1 possibility a 2011 to 2013 model. Could anyone suggest any tips and anything I should be vary off before purchasing it. Also my budget is around 25k. Will I be able to buy any good one at such price. It would be helpful. Currently riding a scooter. So the shift