r/ATV • u/TalismanJake • 15h ago
Photos Raptor 700 50th Anniversary
2006 Yamaha Raptor 700 50th Anniversary. 🇿🇦
Had it since new. She’s a beast.
Full HMF System + Intake.
r/ATV • u/TalismanJake • 15h ago
2006 Yamaha Raptor 700 50th Anniversary. 🇿🇦
Had it since new. She’s a beast.
Full HMF System + Intake.
r/ATV • u/SlntShrkStrnglr • 18h ago
Got a 2015 hisun sector 1000 and the issue in having it stalls out only in gear, in neutral I can run the RPMs up and down but I'm gear it'll die, I have replaced the fuel pump fuel injectors brand new throttle body, tested the fuel pressure getting good FP and pressure doesn't fall out when the UTV dies. Compression is good also, the only issue I can physically see is the engine seems to have a little too much play to me as you can see in these videos, has anyone come across something like this? What are you guys thoughts?
r/ATV • u/Real-Jicama-1399 • 19h ago
Do you have to buy a whole new cam , or can they sanded down? 2016 sportsman 850 highlifter
r/ATV • u/gmehodler42069741LFG • 1d ago
Ok, when I have the flywheel set to t in the timing window (per every video ive seen) the valves were way out of spec. Put into spec and it clatters like crazy. When the flywheel is at f (fire) the lifters are super loose and wobbly which is my noise. What am I doing wrong?
r/ATV • u/jgray6531 • 1d ago
Hey guys. When ever I turn the fuel on, it pisses out of this drain. Any suggestions?
r/ATV • u/No-Dot-7447 • 1d ago
I bought a Chinese ATV that didn’t run and found out it has no spark. The guy gave me a wiring diagram but there are so many random wires disconnected that I’m not sure where to start. Do I just buy a new generic Chinese wiring harness? Or where do I start to try and get spark? The head lights turn on but I tested the plugs and there’s no spark.
r/ATV • u/donzi39vrz • 1d ago
I have a 2018 Honda Rancher 420 FM that has a light bar on a button switch in what I assume is replacement of the headlights. The headlights do not work however the tail light does. I've checked fuse and it's good. Replaced to be safe. How can I figure out if the bulbs are dead or what else it might be?
r/ATV • u/Jbenjamin42 • 2d ago
Simple as heading states. New battery, cleaned carb, new spark plug, getting spark and fresh gas. Neutral light is on and I am squeezing brake just in case. Fuel is on and it is getting fuel. Not sure where to go from here. Thanks in advance.
r/ATV • u/No-Dot-7447 • 2d ago
I’m buying a Chinese atv today and it won’t start and hasn’t been ran for 2 years. Does the engine sound healthy when it turns over and does anyone know where I should start to figure out why it won’t run?
r/ATV • u/AntUnlikely3575 • 2d ago
I was using my snow plow pushing snow. ATV stalled. When I tried to downshift into neutral to start it and it wouldn’t go out of gear. I can cycle from 1-5 and back down but it won’t go into neutral. I’ve tried rocking it back and forth as well as pushing it.
Any thoughts? I’m at a loss of what’s going on.
r/ATV • u/zdemerchant • 2d ago
Looking for some help from old Honda Fourtrax owners, i got a 1987 Honda 350D for a good deal, engine is great but missing a few small pieces of plastics. Specifically the side panels that sit between the front plastic body and the rear set. Wondering if anyone who has these would be able to send a top down picture of the front and back with measurements? I've got a 3D Printer and am slowly creating parts i am missing to make it a bit cheaper to repair.
r/ATV • u/Chemical-Rip-4065 • 2d ago
Hello, ive recently bought a Loncin ATV. When i bought it it ran rough, died on full throttle when standing still etc. Backfires from either exhaust or carb (Dont really know)
Ive cleand the carb, with a brush and ultrasonic cleaner. Changed sparkplug and put all new 95 fuel in it. (regular gas in sweden)
Yet it still runs rough. Especially when cold. If its warm it runs quite good without any load or driving. But as soon as i try to drive forward and give it to much gas it dies and backfires. Im only going to use it as transport/snow plow. So its pretty important that it works in the lower speed rather at higher speeds. If i'm really gentle on the gas i can get it moving and eventually going.
I'm out of ideas so anything will be helpfull.
r/ATV • u/Critical-Most-811 • 2d ago
(2004 Honda 400ex) What am I doing wrong? Whenever I put my valve cover back on, one of the rocker arms to my valves seems like it’s way too lose, when I attempted to tighten my valve clearance, it goes all the way down to the point I can’t put the fastener back on. What am I doing wrong??
r/ATV • u/DriverIndependent981 • 2d ago
I’ve got a near-new CFMOTO U10 Pro Hunt in Australia. It shut off while I was driving uphill the other day, but the dash stayed on. At one point it even said it was moving while it was sitting still in Park.
Now it starts normally some of the time, but other times I get one solid clunk from the engine area and it won’t crank. The headlights stay steady when it happens. I’ve also seen the check engine light come on since it first cut out.
Has anyone with a U10 Pro had the same thing? If your dealer found the cause, what did it turn out to be? Wondering if it’s a loose battery or ground connection, a starter issue, or something to do with the dash thinking it’s moving.
r/ATV • u/Gengar_avax • 2d ago
r/ATV • u/isuckmydadscock356 • 3d ago
one hellofa fun thingy. #deathwishATV
Hey all, long time listener first time caller. Im looking to buy a project to work on over the winter. I see tons of used 4 wheelers that need work for pretty cheap. I know, spend the money on something that runs.
Im a tinkerer, was a mechanic for a number of years, and just overall am mechanically inclined and love figuring out how shit works and how to fix it when it breaks.
What would be a good platform to work on/rebuild that has good parts support, easily accessible parts and manuals etc? Im thinking a Fourtrax but could be open to anything except artic cat, because eff them.
Thanks!
r/ATV • u/Haunting-Fortune-292 • 2d ago
I’m really just a beginner looking for something fun to ride on & learn, But still not really in preparations for something like a 700cc, I also particularly don’t want to spend my evening every day at the mechanic, What are opinions on this one?
For context I’m 186Cm tall, and it’s either between this or a keeway jumbo because of my budget.
r/ATV • u/Experiment_786 • 2d ago
Hello I’ve got a new to me 1987 moto 4 350. The issue I’m having is a weak or intermittent spark and it won’t start. Grounding against the frame will show one half good spark and nothing else as show in the video. The spark is blue a lot of the time. Any ideas on what to do next? Parts I have replaced: ignition coil, CDI box, carb (unrelated), ignition switch, kill switch/headlight/start button control, and spark plugs, fuses. Thanks in advance.
Hi guys
I have a 2008 Yamaha Raptor 250 (YFM250RX) and I’m trying to diagnose a running issue.
The symptoms:
Every time I install a new spark plug, it becomes covered in thick, dry black carbon soot after just 1–3 minutes of running.
The exhaust produces black smoke, especially when I give it throttle.
While riding, the ATV eventually starts bogging down, occasionally backfires once, and then stalls.
Sometimes it starts perfectly, sometimes it has trouble starting.
Compression readings were approximately 6 bar cold and 6.5 bar hot, with the throttle fully open.
The factory service manual specifies a minimum compression of 9.2 kg/cm².
I’ve recently removed and cleaned the carburetor twice, but the problem remains.
I suspect the carburetor is running too rich or overflowing, possibly due to a faulty float needle, incorrect float height, or a choke/enrichment plunger that isn’t closing properly.
Interestingly, after opening the air filter housing, the ATV started much more easily.
My questions:
Would you start with the carburetor (float level, needle valve, choke)?
Could weak ignition or incorrect ignition timing cause this much carbon buildup and black smoke?
Could low compression contribute to incomplete combustion and plug fouling?
Is there anything specific to the 2008 Raptor 250 that I should inspect?
I’m happy to work on it myself and would appreciate advice from anyone familiar with this model.
Thanks!
r/ATV • u/Abject-Designer557 • 3d ago
I'm looking for a 70cc atv, do yall got any good recommendations? I keep hearing about the kayo fox 70cc but if yall have other options I would like to know