Long story short, consistent problems with a water bath. I’ve given up on placing the spring form pan in this throwaway aluminum pan. Too many times I end up with water under the cheesecake and my center is mushy.
Instead, I plan on filling it 1/2-1/3 with boiling water one rack below my cheesecake. Preferably right before putting the cheesecake in the oven.
My options to do so involve boiling water in as many pans as needed on the stove top. (First filling the aluminum pan and filling pots from that measurement)
Is this overkill, is this a good vs bad, idea?
Any advice on boiling the water? Can I cut out the pots and heat this pan on the stovetop (topped with aluminum foil?
What temp should the middle of a pumpkin cheesecake be at when it’s “done”? 150’ F?
What should I use to slide between the edge of the cheesecake and rim of the spring form pan? And when? (After the hour(?) sitting in the oven after I turn off the heat? Ie when I plan to place it on a cooling rack?) Should I use a sharp knife? Butter knife? Something else?
Apologies for all the questions, I am just determined to get this right today.
Help 😇. Any would be appreciated greatly.