r/Datsun • • 1d ago

My 79 620

Post image
162 Upvotes

A work in progress. Currently has the L20 with a 4 speed. I have a 5 speed for it, a coilover setup for the front and a linked H233B with disc brakes for the rear. Considering a KA24DE in the future but will enjoy the carbureted motor for the time being. Love how so many parts are available brand new from Thailand.


r/Datsun • • 22h ago

Bodykit info

Post image
26 Upvotes

Found on marketplace anyone have information on the body kit on it?


r/Datsun • • 1d ago

Friday cruise

Post image
122 Upvotes

r/Datsun • • 1d ago

https://www.instagram.com/p/Df-Ja8gFy4s/?hvrq=MWMwdzEyMWI3czd2OQ==

Post image
78 Upvotes

r/Datsun • • 1d ago

Su Carb Problems

1 Upvotes

I'm getting gas leaking out the front carb. When I lift the piston by hand it just sprays out. I have an electric pump so I can do it with the car off. The back one never leaks and no gas comes out when I lift the piston. I'm assuming it's because there's not enough pressure since it's leaking out the front. I rebuilt the carbs so they have brand new needles. I also adjusted the float countless times. Even if I adjust the float so it touches the needle very quickly it still leaks. I tested and the floats do float. Any ideas? It's a low pressure pump but is it possible it's just too much for the needle and it's overwhelming it?


r/Datsun • • 1d ago

1982 Datsun 720 electrical question.

Thumbnail
gallery
9 Upvotes

I recently acquired this 1982 720 King Cab. The previous owner told me about the issues it was having and today I began checking into them. The lights were not working and after chasing the wires I found these wires that connect to the steering column do not connect to anything on the other end. Can anything tell me what I am missing that needs to plug into these? (It’s the red and yellow wires in the second photo)


r/Datsun • • 2d ago

To the cars... more notably, the 610/180B

Thumbnail
gallery
157 Upvotes

Here are some of the ones in my stable at the moment. The two-tone 73 sedan is my girl. It has been in my life since I was three and she was eight.

The 76 coupe is slowly coming together. Still sorting out engine/transmission options.

The 75 sedan is going to get some love here starting next summer. Stay tuned.

The 73 wagon is my son's car. Get them into 610s early - they won't have the money for drugs. Lol.

We are a no kill shelter. We love our 610s.


r/Datsun • • 1d ago

The Drive on Instagram

Thumbnail instagram.com
0 Upvotes

r/Datsun • • 3d ago

1982 Datsun 280ZX, New misfire between 1,200–1,500 RPM when warm

9 Upvotes

Hey everyone

I have a 1982 Datsun 280ZX with factory EFI. I've been dealing with some fuel related issues, but recently a new problem popped up.

Existing issue (mostly when cold)

For a while the engine has been running rich, with a noticeable smell of raw gasoline from the exhaust. When starting the engine cold, it runs pretty rough, misfires, and shakes. However, once it warms up it usually runs smoothly and the rough running goes away but still runs rich.

The new issue is I've noticed that even when the engine is fully warmed up (temperature gauge sitting around the middle, after driving for half an hour or more), it starts misfiring and shaking between approximately 1,200 and 1,500 RPM.

It almost sounds and feels like a 2-step rev limiter😂 Once I get past that RPM range, the engine runs smooth.

I've also noticed something strange with the fuel tank, when the fuel level is very low, like almost empty, the engine starts surprisingly easily and pretty fast that even I can't hear the starters sound, even after sitting for several days. However, after adding around 10.3 gallons of fuel, cold starts become noticeably harder and require few seconds of cranking.

Also, when opening the gas cap I can hear a noticeable hiss of escaping pressure and smell gas. Also this is an old problem.

I've checked

1-Ignition timing is set to approximately 8–10 degrees BTDC.

2-Spark plugs and spark plug wires are new.

3-Ignition coil produces a strong blue spark.

4-Checked fuel pressure after the fuel filter and is around 30 PSI at idle and rises to approximately 40 PSI when revving or removing the fuel regulator vacuum hose.

5-Coolant temperature sensors have been checked and seem to be working properly.

6-The coolant temperature sensor on the thermostat housing was recently replaced.

Has anyone experienced similar issues with an L28E?

I'm particularly interested in what could cause the new misfire at 1,200–1,500 RPM even when the engine is fully warmed up

Any advice on what to test? Thanks alot


r/Datsun • • 3d ago

Saved this 620

Thumbnail
gallery
113 Upvotes

Bought this last December from a farm in Washington state. Took about 3 months to find a truck who could winch it up and bring it to Texas. After a lot of fun times finding parts she’s finally saved. Last registered in 1989 now ripping and working for me daily.


r/Datsun • • 3d ago

Gray and white are mine. Safari gold is an acquaintance.

Thumbnail
gallery
259 Upvotes

r/Datsun • • 3d ago

240z Ls build

Thumbnail
gallery
70 Upvotes

Finally have the time to spend a few days straight on her and hopefully finish her by Friday


r/Datsun • • 4d ago

Ruff day when the stethoscope comes out

Thumbnail
gallery
38 Upvotes

r/Datsun • • 4d ago

Datsun Sunny 🛻

Thumbnail
gallery
157 Upvotes

Just because there were not enough pickups recently here.


r/Datsun • • 4d ago

Adding to the Pickup trend....

Thumbnail
gallery
482 Upvotes

My '74 620. KA24DE/5 speed swapped. Beebni coilovers, 4 wheel disks, Recaros, restored dash with speedhut gages, repainted in the factory "Cactus Green" and lots of other stuff. Currently swapping the ECU to a Link G4X.


r/Datsun • • 4d ago

To the trucks

Thumbnail
gallery
62 Upvotes

Adding in to the trucks that keep popping up.


r/Datsun • • 4d ago

Mom truck update, engine is back from the shop

Thumbnail
gallery
16 Upvotes

Back from the shop, will get a little more work done before assembly. Putting in larger pistons so the engine has been bored out. She gunna be fast boi


r/Datsun • • 4d ago

Did someone say pickup?

Thumbnail
gallery
47 Upvotes

1989 Datsun/Nissan 1400 pickup in completely stock configuration.


r/Datsun • • 4d ago

Since we’re doing trucks, my work in progress ‘73

Post image
132 Upvotes

r/Datsun • • 4d ago

280zx Cup Holder

39 Upvotes

I finally wrapped up The center console cup holder for the 280zx it’s printed out of ASA-CF.
It’s designed for easy install and removal while the center console door still closes.
I have it listed on Etsy under MspeedIndustries for those interested.


r/Datsun • • 4d ago

Stupid question, but what is this sensor on my L28et?

Post image
6 Upvotes

r/Datsun • • 5d ago

Not enough pickups in here

Thumbnail
gallery
545 Upvotes

240z subreddit or what?

Here’s my lil hustler


r/Datsun • • 5d ago

Did somebody say "pickups"?

Thumbnail
gallery
264 Upvotes

r/Datsun • • 5d ago

Anybody ever seen a finned z?

Post image
159 Upvotes

This is up for grabs before it goes to scrap on my local fb, never seen a zcar with fins before. Makes me think of a mini batmobile