I’m getting the following fault on my 2018
BMW 335d F31:
2C3200 – Swirl flap, plausibility: mechanically defective (lever break detection).
Swirl Flap actual position -4%
Swirl Flap target position 40%
Raw voltage of the swirl flap position 405.35mV
Swirl Flap - Initial duty cycle 0%
It sounds like it should be a straightforward fix, but I’ve already replaced the actuator and checked the linkage, which appears intact. With the actuator removed, the swirl flaps move freely. The manifold and flaps are clean, with no carbon or soot build-up causing them to stick.
If I start the engine and clear the fault code, the swirl flaps operate normally. However, once the engine has been switched off for a few minutes, the fault returns on the next start and the flaps stop operating. Clearing the code restores operation until the next shutdown, and this happens consistently.
Has anyone experienced this or have any suggestions on what to check next? Thank