[Review Request] 4-layer AIO drone board: ESP32-S3 FC + 4-in-1 AM32 ESC + ELRS RX, 2S, 55×115 mm
Hi! I'm a student and I designed an all-in-one board for my own 2S mini drone. Before I pay for JLCPCB assembly, I'd really appreciate a second pair of eyes for any obvious mistakes.
What the board does
FC: ESP32-S3-WROOM-1-N8, ICM-42688-P IMU (SPI, own LDO), SPA06-003 baro, 16 MB W25Q128 blackbox, USB-C ESC: 4 channels, each AT32F421 (AM32) + NSG2065Q 3-phase gate driver + 6× DOY180N03T (30 V, 3.3×3.3 mm). The gate rail comes from a TPS61170 boost (VBAT → ~9.9 V). Battery current via a 0.5 mΩ shunt + INA186. RC: ExpressLRS 2.4 GHz RX on the board (ESP32-C3 + SX1281, copied from OpenRX-Lite), U.FL antenna. Main control and video come from a DJI O4 Air Unit (SBUS + MSP OSD) soldered to pads. Power: 2S LiPo via XT30, 5 V / 3 A buck (LMR51430), USB/battery power mux (TPS2116), separate 3.3 V LDOs. PCB: 4 layers, 55 × 115 mm, 1.0 mm, ENIG, JLC impedance stackup, all parts on top (one-sided assembly) Motors: 1103 8500 kV on 2S, 3" props. I expect roughly 10 A peak per channel.
The ESC sheets copy the OpenDrone/OpenESC reference design (CERN-OHL-S), adapted for 2S.
Where I'm least sure (please look here first)
- ESC power stage and layout: FET placement, gate loop, the 1206 input capacitor bank and the electrolytics near the XT30. Is the current path from the battery to the 4 channels wide enough?
- Gate-drive supply at 2S: Boost to ~9.9 V for the NSG2065Q. It has an 11 V TVS clamp and a 0.47 Ω input resistor against plug-in spikes. Is this approach sane?
- Grounding: One solid GND plane (L2). Motor currents and the IMU/ELRS share it. The IMU sits in the middle of the board, away from the FETs.
- 2.4 GHz RF: The 50 Ω trace from the SX1281 filter to the U.FL connector, and the ground vias around it.
- Thermal: 1 oz outer copper, no via-in-pad under the FETs.
Any feedback is welcome. Thanks a lot!
