I’ve been struggling with a leak in my prefab sliding door shower for a few months now - and have removed the doors, stripped out all caulk, cleaned it well and am attempting to waterproof it.
It was installed by previous owners and is not fully level. Because of this, water runs down the track and has been leaking out of the shower and into the wall. I’ve cut out drywall and am repairing that area.
This is the corner causing issues.
I removed a disintegrating rubber seal going down the two track lines, however am finding that this should be left open. Is that correct?
My main question is how can I properly seal this red area so that water will not go into this track, and seep into the green area/wall.
The last time I used clear silicone it seemed to fail pretty quickly. I purchased locite boat marine and Google seems to point to getting it in all the cracks well, but I imagine that water will still run down the track and into the green area/onto the floor.
Any advice is appreciated.