Hi all! i have a question.
I have dual Sparkle Guardian B580s, for locai ai experiments. I had my setup running before but sonce two/three weeks both cards go into Recovery Mode when both are powered. Each card works fine alone.
I've been stuck on this for a while and hope someone has seen it before and can help.
Other symptoms:
Shutdown takes very long.
Once the PC booted straight into the BIOS.
Both card show "0 GB Dedicated" in Intel Graphics Software, and no firmware version is shown for either card in Intel Graphics Software.
My gear
Motherboard: ASRock B850M Pro-A WiFi, BIOS 4.60 (AGESA ComboAM5 1.3.0.1d)
CPU: AMD Ryzen 8400f
PSU: Corsair RM1200e (both cards on separate cables)
RAM: Corsair DDR5 2×8 GB 6000 CL36
SSD: Lexar NM610 Pro 500 GB (M2_3 is empty)
OS: Windows 11 [version]
Driver: 32.0.101.9175 (WHQL), Intel Graphics Software 26.36.2702.2
AMD chipset driver: 8.09.10.2141
BIOS settings
CSM disabled, Fast Boot disabled
Above 4G Decoding and Re-Size BAR enabled
iGPU disabled, dGPU Only Mode enabled
PCIe power management features disabled
PCIE1 Gen4, PCIE2 Gen4 [also tested Gen3/Gen4: no, result
PCIE on x4x4
What I already tried (none fixed it)
DDU plus a clean driver install, including with both cards powered during the install
CMOS reset
BIOS update from 4.10 to 4.60, then reapplied all settings
Resizable BAR off as a test
Fast Startup off, PCIe Link State Power Management off in Windows
TdrDelay = 10 and TdrDdiDelay = 20 in the registry
Disabled the Intel services (intelgraphicssoftwareservice, IntelGFXFWupdateTool).
Memory Integrity off as a test
Questions
Has anyone run two B580s with one in a chipset x4 slot? Did you need specific settings?
Could this be a firmware mismatch between the two cards? Is it worth reflashing with the ARC Firmware Tool or igsc?
Should I try an older driver?
It has worked before (allthough on a x4.4/x1.4 setting) but now they instantly go to recovery mode, what can I do?
Thanks