'Ello, me again.
I've been busy making some of these tokens for my 94s ratlings.
So
This is what I got so far
Fixers dedicated target. The red crosshairs
Sneaks evade and optics. The curved arrow and the HUD glow tokens
Spotters spot. White spot on red background
Battle mutt early warning. Comicbook style exclamation mark.
as well as some apl +1/-1 double sided tokens, guard/wound. (Rusted metal/ blood splatter) and 3 objective markers (40mm hatches)
All made from styrene. The "base huggers" 1mm styrene drew a 52mm² on the styrene. Then lightlyscored the cross from corner to corner and a cross measured halfway along the sides. This sectioned everything into 8. Then I got my cheep and nasty circle cutter that was so annoying I think I need to invest in one that the blade doesn't wonder or juat snap. I mean, I wasn't applying that much force. It must be the flex of the plastic body of the cutter and the arc of the cut. It doesn't suffer so much on the bigger sizes.
Anyway. So after dividing ine square into 8 I then cut the outer diameter at 50mm and the inner at 25mm diameter which made the ring. Then because I pre scored the sections whilst there was a way to mark it evenly before cutting it round. It made it easy to slice them into even wedges that hug the bases od the ratlings. Then I painted them.
I won't twll tou my paint techniques as there is much better tutorials all over the Internet on how to paint. But there was involved an old stiff brush scrapping along a cocktail stick for the blood splatter.
Now, the 3 objective markers. I wanted to creat something that would fit anywhere in the grimdark of the far future and made sense. I came up with hatches. I thought it was pretty clever. Hatches not only have you believe it leads to an underground bunker or tunnel system of some sort, but your objective is to get there, to enter or stop others for doing so. Or to stop something getting out or prevent opponent from unleashing something. Or its a land mark for some kind of rescue or drop zone.
The way I made them was starting with 1mm styrene cut into the 40mm base disc. Then ½mm styrene to make the doors. All I had was a long thin strip so I had to cut rhem one at a time, zig zagging from sode to side on the strip. I only had one shot at 30mm hatches and as you can tell I pulled it off. Then marked where the handles and hinges was going to be and cut them in. Luckily the center of the doors have a dimple where the pin from the circle cutter stabbed into it which helped with marking and aligning. Once rhe dores was glued to the base, I cut up some 1mm rod styrene to make the hinges.
The paint scheme I decided was rusted metal. Numbered and with hazard stripe down the middle. Enough so you can see where it is and what it is without over powering the board is the idea.
As you can see from the sneak stepping on the hatch. There isn't too steep a profile to wobble the minis when they step on it.
Anyway, thanks for reading. Any comments feel free to share. Hope you enjoy.