Nest Learning Thermostat Wire Identification Issue
I have a Rheem two stage gas forced air furnace and Rheem single stage AC unit.
I recently moved into this house and there was a Honeywell thermostat that I wanted to replace with a nest.
I learned that the typical nest cannot handle a two stage furnace so a family member gifted me their nest learning thermostat. That thermostat worked fine with their two stage furnace at their home.
When I connected to my furnace, it gives me various error codes, and then shows me the diagram of the wires that are connected. Sometimes it’s correct, but then within seconds it will switch to an entirely different wiring arrangement sometimes showing that I have a heat pump.
It bounces all around and never seems to be stable no matter what I try to do.
I do have a C wire, and I’ve disconnected it and reconnected it to my wires numerous times.
I verified through the nest app and also through Claude that the wiring is correct at both the furnace and the thermostat.
But for whatever reason, the nurse just keeps bouncing back-and-forth between wiring that it thinks it senses.
As a last resort, I did replace the internal battery but the results are the exact same.
Anyone have any ideas with this?
