r/SkyLine • u/daelin0013 • 5h ago
R32 Autech Review
I believe the only driving review of an R32 Autech :)
r/SkyLine • u/daelin0013 • 5h ago
I believe the only driving review of an R32 Autech :)
I have a 1993 R32 with a completely stock N/A RB20DE motor but recently found out my ECU has issues due to internal corrosion. My friend however has an OEM 1991 GTS4 RB20DET factory ecu with a nistune board he’s not using anymore from upgrading to haltech and was willing to give it to me if it plugs and works without needing to rewire or re-pin anything. Local Nistuner said they can retune the gts4 ecu to a rb20de setup but can’t verify if the harnesses on my car will match up. Can anyone verify if a GTS4 ecu plugs right into a RB20DE wiring harness and works with no pin-out differences, etc. Issues?
r/SkyLine • u/yohoes • 18h ago
The origin of the Godzilla name... everything else helped lock in the mythology but this is where it actually came from.
Bought this a couple of years ago, couldn't believe my luck. Thought it was worth the upload!
r/SkyLine • u/togatrojan • 2d ago
My GTT has factory Xenon lights. I was wondering if there was a good add-on for daytime running lights. Thanks!
r/SkyLine • u/SJNFury • 3d ago
So my coil packs for my stock rb25 Neo engine have just started dying and I’m looking to replace them with a slight upgrade. My plans for my car are to swap the trans mission out for a zf 8hp 8 speed auto trans so I can have decent gas mileage and daily drivability as traffic were I live is horrible and just about every way I can take to work is also under construction. As I’m not looking to do crazy power, 300-400 at most at the wheels with a turbo. That’s the end goal. But for now I just want to do the transmission swap. But an issue has now arisen, my coil packs are dying and I’m seeing this as an opportunity to do a slight upgrade to them so that they can handle the higher power.
Does anyone have any suggestions as to what I should get for coil pack replacements as well as the spark plugs? I’m also not sure if they’ve ever been replaced, my car over all is stock and has about 93-95,000 miles on the odometer after doing the kilometers to miles conversion calculation.
And before anyone gripes at me for not doing a manual swap, the car came to me with a 4 speed automatic transmission, and I don’t like the idea of having to learn to drive a manual transmission in almost constant stop and go traffic. (Now I can drive a manual, but I still have to get used to being able to get the car to start moving in first gear.) That, and I want to have good gas mileage cause gas is still pretty expensive.
r/SkyLine • u/Top_Cook4646 • 3d ago
ive been wanting this car for like 3 years now and through so many ups and downs i finally have it. I traveled interstate to get it and i love it. Its a series 3 Ti auto 1988.
r/SkyLine • u/LivingBetter8885 • 5d ago
My R34 sprung a leak from the common place bottom fuel vent line piece (last photo) so I opted into a fuel cell to save the hassle of remove and replacing the tank again, I pulled it and plastic welded it to the best of my abilities and a few days later it sprung a leak again so I got the Evil Energy fuel cell kit. That being said I know this isn’t for everyone but if your in a position that repair or replacement isn’t an option then hopefully this can help.
What I used and what you need may vary so keep that in mind that this is just how I did it and not a road map of how to you should or have to do it!
What i ordered that don’t come with the kit:
2x 90 degree 6an fittings comes in a 2 pack
8x straight 6an fittings come in packs of 4
2x 6an to 5/16 quick connects male to get the an lines into the factory lines that send fuel to the front and return line, Google said Feed was 3/8 and return was 5/16 but both of mine are 5/16 so this may very I’m not sure.
We traced the carpet on a thin piece of plywood and cut it out and in half to create a solid mounting surface for the fuel cell, do this however easiest because it just needs to support the weight of a full tank. (I got the 15 gallon size)
Splice however you’d like into fuel pump harness and fuel level sending as well but be sure to make it safe because you’re working with fuel here.
I did not install the fuel pressure regulator as it’s not needed, im stock motor and no need to mess with it but its nice to have just incase I want to upgrade to the included unit.
Here’s some possibly helpful information if your doing this yourself:
1: AN lines and fittings aren’t something you should attempt without proper tools or having a professional assist you with
2: measure out your line and make a plan on how you want it to be routed before you start cutting lines.
3: Amazon prime is your friend in my experience with this
4: the quick connect furthest towards the front is your feed, 2nd is your return, and 3rd is a vent line which will not be important for your fuel cell, it’ll need a new one routed from the cell.
5: either bottom port is fine to use for your feed, either top port is fine to use for your return, be sure to use one of the top ports of the cell to connect your vent, I used the rubber grommet top left of the trunk to route my vent line outside of the vehicle, just put a small filter on it and be prepared for the smell of fuel to be present outside the car, bonus points if you properly seal everything so no vapors get back into the trunk
6: have fun with it all but be safe!
7: if you are pulling the tank out, do your best to siphon or drain the tank and after your done fill it with water to displace the fumes and it’ll make it a little safer.
That being said feel free to ask questions and also keep in mind I am not a professional, this is just personal experience because finding this information myself wasn’t the easiest so I hope this may help someone out! If you wanna see more about what I’ve done check me out on Instagram @r34.gxbrial
r/SkyLine • u/ObjectiveAd9242 • 6d ago
What an absolute task this was but after a few days of wrenching I got the twins out and swapped with a set I had rebuilt myself. This was mainly to see if I had it in me to be able to do and also to see if these turbos held up after I used a rebuild kit on them. I can happily say the car now boosts and pulls like a beast. I’m hyped to be done and to have it work. Now I can at least drive and enjoy the car while the new engine gets done and not have to rush to swap it out. A bunch of you have given some great feedback during this process and I appreciate this community.
r/SkyLine • u/InstructionSquare894 • 7d ago
So my r32 20det sounded like someone breathing rasply, would try to die while driving sometimes succeed, not idling right, stalling, I changed the MAF it was worse puffing out black smoke jerking when winding up boost, swapped the maf back to the original, (did a ecu reset everytime)
Was driving mint maybe something was loose also took the seal from the clearly faulty replacement, but after a good 40 minutes of driving and a decent boost it decided to start chugging trying to die, i had to pull over to let it stall, started algood got it home.
The next day no issues for a good 40 minutes until I came up to a roundabout and it stalled wouldn't turn over for (what felt like forever as I was blocking traffic) but was probably only 4 minutes, finally got it going, headed for home and was trying to die the whole way home had to pull over once to let it stall, im taking it to the shop on tuesday for them to read the ECU, but any thoughts on the issue tho? Boost leak, vacuum leak?
r/SkyLine
•
u/stockf87
•
10d ago
Just picked this up around May of this year, re-done in bayside blue
r/SkyLine • u/ObjectiveAd9242 • 10d ago
Guys I’m so close but I cannot get these last two nuts off. What were some tricks you’ve used? My wobbles won’t get it, box wrench can’t seem to get it, I’m absolutely dying.
r/SkyLine • u/ObjectiveAd9242 • 10d ago
Decided to pull the front pipe just to see. Lo and behold what was sitting in the cat.
I’ve got a spare set of turbos I may just swap them for fun while I wait on the head to get done being built. Fun times.
r/SkyLine • u/GabRB26DETT • 11d ago