r/SleepingOptiplex • • 13h ago

Case swapping dell optiplex 3040

Thumbnail
gallery
14 Upvotes

I recently completed a case swap on my Dell OptiPlex 3040 MT, moving the original Dell motherboard into a completely different gaming case.
The original PC had an Intel Core i5-6500, 8GB DDR3L RAM and its original SSD with Windows installed.
I moved everything into a white Kolink Observatory Midi Tower RGB case. The case came with RGB fans and lighting, which I connected using the included RGB controller. I also installed a Corsair CX750 PSU using a Dell 8-pin to 24-pin adapter and a Thermalright Assassin X 120 ARGB CPU cooler with its own RGB fan.
One of the biggest challenges was mounting the motherboard because the Dell motherboard has a different mounting layout. I managed to screw in the top-left and top-right motherboard screws normally. For the bottom-left and bottom-right mounting points, I used nylon standoffs to support the motherboard.
Another challenge was getting the front panel power button working. I managed to get it working by plugging the POWER SW connector into the far-left pins on the motherboard. I left the other front panel cables disconnected.
I also had to work around Dell’s proprietary 8-pin motherboard power connector using an 8-pin to 24-pin adapter.
After getting everything installed, the PC booted straight into Windows using the original SSD. The front power button works, the Kolink RGB fans and Thermalright cooler lighting work, and temperatures are looking good.
I’m pretty happy with how it turned out, especially considering I managed to reuse the original motherboard rather than replacing it.


r/SleepingOptiplex • • 4h ago

my optiplex business while getting gta6 ready give me some ideas for some optiplex builds

Post image
3 Upvotes

r/SleepingOptiplex • • 5h ago

Connecting a DeepCool PN750D PSU to a Dell Inspiron 3470 motherboard in an ATX case?

0 Upvotes

Hi everyone,

I’m upgrading my Dell Inspiron 3470 by moving the motherboard into a standard ATX case, and I want to power it using a DeepCool PN750D ATX power supply.

Since the Inspiron 3470 is an OEM board with proprietary power/front-panel connectors, I want to make sure I wire everything safely without damaging the board.

Current setup:

Motherboard: Dell Inspiron 3470 (stock OEM)New PSU: DeepCool PN750D (750W ATX)New Case: Standard ATX case

Questions:

Which specific PSU adapter cable (e.g., 24-pin to 6-pin or 8-pin Dell adapter) do I need for the Inspiron 3470 motherboard?Are there any specific pinout quirks for the front-panel power switch/LEDs or BIOS fan/power errors I should watch out for when moving this board to an ATX case?

(Note: Add clear photos of your motherboard's power headers and front-panel pins when you post!)

Thanks in advance for any help!

If there are any other suggestions for my setup feel free to say.........