AUSTIN, TX. Bottom line first for non-readers. Build in the center, not on the sides.
With 80% of the tread remaining, for $1500 on my Transit 250 i had to replace my Cooper tires. Why? The van developed a hard right pull that I kept attributing to alignment issues and I had several alignments. Each time, the guys said the alignment was fine, its the fact that roads are not flat, they are semi-circles with crowns in the middle and, all cars pull to the right and have since 2012 so forget about it. But on my Los Angeles to east coast ride recently, I literally couldn't stand the right-side pulling. ALL roads are like this?
I went backwards to Austin, TX and stopped in a Discount Tire shop and the guy said, for the first time ever, its not the alignment or roads, its the tires. He said that once a tire develops abnormal wear, no amount of alignments, balancing or rotating will correct it. The weak areas of the tires will just get worse until you change them. But still, WHY?
After new tires, they sent me to another branch to check alignment. While there, the alignment guy took an abnormal amount of time to explain whats going on with the van. He said that in his alignment classes, they had a lab in the form of a Transit 350 hightop and into the van they placed huge varieties of loads and load placements to see what effect loads had on camber.
To everyones surprise, no matter how you loaded a van, any load on the left or right sides changed the camber by several degrees, even just 5-10 lbs which he demonstrated by adding weights to front-end components. But in any loading of the van where you were restricted to center weight, even stacking right up to the ceiling, no effect on camber! He also noted this situation applied to, guess what, the van sliding door. He says a weight bias comes from the factory because the slider weighs more than the opposite body panel.
- Its not the tires, alignment, tire pressure or road crowns, its the build.
- Dont try to balance the van left and right, keep all weight off the sides and use the sides for fore-and-aft walking.
- If coming up short on a center build and have more crap to put somewhere, keep heavier weight on the drivers side even if there is no passenger.
- Reduce build weight and what else you carry as much as possible.
He did have one positive note. A lot of the camber problem can be mitigated with air suspension that allows for individual wheel adjustment. Im not sure how air suspension relates but he said he would setup the van should I ever go that route.
In my case, I put new Michelin tires, got heavy weights off the sides, got rid of stuff and, with a new alignment too, now the van is riding straight. The tug of war with the steering wheel literally drove me out of my mind. If the van isn't rolling comfortably, neither will you and you'll pay for it in tires. I could not afford a sudden and unexpected $1500 expense and dont want to go through this again.
I have been sketching out possible center builds and its a challenge. A lot of drop-leafs and fold-outs. Obviously, if someone doesn't care about expensive and premature tire wear or the van not rolling correctly, nevermind!