r/ballpython • u/spooksaf • 12h ago
Heating issues with my new 4x2x2 terrarium - Help!
She is about 3.5 years old and got upgraded to a 4x2x2 a few days ago. If I don't figure out a solution to my heating, I'll have to put her back into her smaller 40 gallon until I fix it.
- Please don't mind the enclosure setup especially the cardboard tubes - I am waiting for things to arrive in the mail and will get her branches, etc, so the setup will be a lot better soon -
So when doing research I was suggested to (by Ai mainly) to get a DHP (deep heat projector) of 80W, and a UVB light. I did just that, and also got a automatic dimmer for the dhp so that it can self regulate after setting the night day cycles. When the DHP is sitting on the mesh top, it has about 22" to reach the top of the basking rock/hide, and its barely even warm, almost just room temp. with no heating, the tank temp is around 74 degrees, and with the dhp on the highest settings the thermometer reads about 83 degrees around that rock
So if 83ish is the highest the temps get around the "basking spot" thats a problem I assume, did I waste the money on the dhp and ceramic lamp clamp and have to figure something else out? I realised that if i raise the basking spot, like make a ramp to go up half way of the tank, it will get a lot warmer but then im also just considering buying a higher W DHP? I guess im just confused cause 80W should have been more than enough to provide proper even for a 4x2x2.
So what would you suggest, or do for your setup? Also I have some black HVAC heat sealing foil tape that I will put accross the mesh top once I figure out where to place the uvb and what to do with the DHP, that might help the average temp increasing but won't solve the basking spot issue.
Thank you so much for your time and help, my snake really appreciates it too!