03 xl1200c for reference, factory front end except for 6+ tubes.
Bearing races have been installed correct, lower bearing has been greased and properly seated on top of a metal dust shield. Lower triple tree with stem slides in, upper bearing seats properly on top of the upper race, shit ass rubber dust seal (replaced bearings and races while I was in there, came with this black rubber one), adjuster bolt goes right in on top of a washer, no problems.
At this time steering stem pinch bolt is OUT, fork pinch bolts are out, forks are out.
As I slide in the brake side fork tube, all good, bolted down. As I slide in the other fork tube, I must loosen the adjuster bolt ever so slightly to properly allign the fork tube. No problem, goes in, now BOTH fork tubes are bolted down.
As I do the typical drop test to loosen the bolt and properly setup my front end, the only bolt NOT in is the steering stem pinch bolt. As I loosen the adjuster bolt the gap at the top bearing increases, and the bottom of the top triple tree begins to rub enough on the neck to hear it.
The adjuster bolt must be loosened so much the damn front end might as well fall right off, stem pinch bolt in or not.
What the hell is going on? Any help is greatly appreciated! Working on my first build. Been riding for a while but this is my first time doing this much!
Thanks yall