Hi!
I recently bought a second-hand dome clock for a very low price simply because I thought it looked beautiful. It was advertised as not working, but I decided to take a chance on it.
After doing some research, I quickly discovered that the problem was a broken/missing tension spring of the pendule. Since this seemed like a relatively straightforward repair, I ordered a replacement spring online.
I believe the clock is a Kern model with a Type 1405A backplate, based on what I could determine from the 400-Day Clock Repair Guide, although I'm not 100% sure. For some additional information, the backplate measures approximately 44 mm x 93 mm.
I ordered the replacement spring from Cousins UK, a 132.5 mm x 13 mm Standard 54 (11B), part number S33396. However, the thickness of the spring wasn't specified, so I'm not entirely sure whether I ordered the correct replacement.
I installed the new spring, and to my delight the clock started working again! It ticks consistently and doesn't seem to get stuck or stop. However, there's one rather big problem, it now runs approximately 10 minutes too fast every hour!
I'm a bit puzzled as to what could be causing this. Could the replacement spring be incorrect, perhaps due to its thickness or tension, or could there be something else going on with the movement?
Does anyone have any experience with these types of clocks or have an idea what might be causing this? Is there anything I can check or adjust to get it running at the correct speed again? I've tried adjusting it using the small adjustment wheel on the weight, but this doesn't seem to make much of a difference.
I'm still quite new to clock repairs, so any advice or suggestions would be greatly appreciated. I'd really love to get this little clock running properly again!
Thanks in advance for your help!