Nobody's coming over this Christmas, just me and the cat, but I'd like to make the desk look a little festive. I'm planning to hang a few small wooden stars near my monitor. Nothing fancy. Just a small weekend project that hopefully won't turn into another unfinished pile of craft supplies.
I've decided to use pre-cut thin plywood stars rather than cut them myself. One thing I can't really avoid, though, is drilling the hanging holes. The stars are quite small, and I'm worried about splitting the wood or accidentally drilling too close to one of the points. I'd rather not spend an afternoon painting them only to snap one while adding the ribbon.
I've been looking at the mini drill from the hoto SNAPBLOQ range for this part. Since the holes need to be fairly small and consistent, I want to get the bit size and positioning right before working on the actual pieces. I'll test on a scrap of the same plywood first, with another piece underneath for support.
For anyone who's made small wooden decorations, how much material would you leave between the hanging hole and the edge? And is there a particular drill bit size you'd recommend for thin plywood?
I'm trying to make Christmas decorations, not create a tiny woodworking disaster on my desk.