Edit, 22 Nov: I got one thing wrong. I said this moves "more air". That compared each nozzle at its own tip, and the tips are 7 cm apart, so it wasn't fair. At the same distance from the duster it's a tighter, faster jet, not more air. Thanks to everyone who called it out. The pictures above are the old ones. The model page has the corrected pictures and numbers.
I wanted a better nozzle for my Wolfbox MF200 and ended up designing one.
It's two parts. The core clicks into the duster and squeezes the fan's air into a 19.5 mm jet. The shroud twists onto the core, pulls some room air in through the 8 vanes at the back, and keeps the jet from spreading out through a 29 mm tube. So it still has punch when you can't get right up close.
I ran it in CFD before printing (OpenFOAM, same fan curve every run): core on its own against core + shroud, at the same distance from the duster.
- 74 m/s vs 51 m/s on the centre line at 25 cm (+45%)
- 54 m/s vs 39 m/s at 30 cm
- push 238 g vs 232 g, so about the same
- a bit less back-pressure on the fan with the shroud on
It doesn't add power. It's an ejector, so all it changes is how the jet mixes with room air. A bare jet pulls in more air on its way, the shroud keeps it together.
On my kitchen scale the real print pushes 260 g. The stock nozzle does 235 g.
A few details:
- 1° taper on the mount so it presses in and seals, plus the bayonet click
- The shroud locks with a 30° twist. It clicks shut and doesn't rattle
- One plate. Core prints bayonet end down with supports only under the centre hub, shroud stands on its tip with no supports
- Profiles for Bambu printers at 0.16 mm. Mine's gray ABS on a P1S, PLA works too
Model: https://makerworld.com/en/models/3637893 MF50 version: https://makerworld.com/en/models/3659016
Video of it on a pile of leaves is in the comments. Ask me anything about the CFD or the design. If you print one, show me.