Hey All! Been over busy lately working on two major saber build projects, both of which I'll post here about in the near future, but while waiting on material and parts I'm still doing other builds. Here's my latest.
It seems to me that most saber hilts have a hexagonal theme, mostly I suppose because the metal lathes they are cut on use three-jaw chucks. So I got it in my head to make an octagonal themed saber, just as a challenge. The base metal stock for this started as square tube with a center hole. I squared that tubing up on a mill, then 3D printed a jig to hold it at 45 degree angles and cut the corners down to make the tube eight sided. Next I dropped the octagonal tube into a 4-jaw chuck on a lathe and bored the inner diameter out to 1" to fit any standard drop-in core or blade.
With the base stock done, I cut the emitter and grip to size, then started assembling and detailing. The emitter is laser etched with a pattern in ceramark and has four see-through holes to let blade light through and four blade retention thumb screws. Below that are concentric tubes of copper and brass press fit into each other and then into the matching slot I turned in the bottom of the emitter section.
The switch section is my favorite Corvus Foundry beveled single-button hole that I ran against a buffing wheel to give it a cloudy surface while leaving the slots shiny. The core breaks between the emitter/button and grip so the bottom section can come off to allow access to recharge.
The grip was the most fun to make. The top is a carefully turned bronze ring that lets the button recess into the ring but also covers the top of the leather strips on the grip. I decided to accent the 8-sided nature of the grip by putting four strips of alternating colored leather vertically along the grip. Before gluing the leather down I grooved a thin slot down the grip lengthwise on a mill so the edges of the leather could be covered by pressing a metal rod into the slot. I alternated copper and brass for those slots to go along with the alternating color strips.
The pommel was a leftover part from some other hilt that I cut down, then I built a set of copper, brass, and steel rods to fit around an aluminum tube and installed that inside, then wrapped the junction to the grip with brass wire.
Press fit the pommel into the grip, pop on a brass covertec wheel with copper nut, and viola! One octagonal themed Old Republic style hilt for your dueling pleasure! Anyone want to fight? :-)