r/maker • • 11m ago

Help Levers redirecting direction

Post image
1 Upvotes

Hi, so first excuse my drawing. I am trying to build a switch (B) that moves left to right, that lifts the point (A) up to open, I don't know how to explain but it's the different axis than B. But I don't know how to make or work.

I am thinking bicycle break wire would be perfect to connect the two. A spring could be used to return it automatically since it only needs to go to one side then reset. And I would need some way to quickly adjust it so the two motions go the distance it needs and set resistance.

I hope that makes sense. I would like to use all off the shelf parts, so like I said break wire, small pulleys, springs. I would appreciate all help I could get in design and material recommendations.


r/maker • • 5h ago

Help Xmas light help

Post image
1 Upvotes

I realize what I'm asking isn't truly a maker project, but I find people in this sub who enjoy this hobby/job to often come up with very simple yet creative solutions to problems. I built my Xmas light setup a few years ago around an ESP32 running WLED and RGB pixels and I love it. What is a headache each year is stringing the lights around my columns. Looping them around the columns isn't that hard, but I literally have to make a loop, get the wires tight, adjust the spacing, etc over and over and over until they're consistent or the effects don't always look right. I usually put staples in every few loops to help, but the entire process is tedious.

Any thoughts or suggestions that don't involve staples or hooks permanently installed? My best idea so far, and I'm unsure how good it even is, is cutting a piece of plastic pipe (like PVC but hopefully clear?) in half so it fits the corners of the posts. Then I can measure and notch the pipe at fixed intervals so when I string the lights they just rest in that notch. Maybe a similar idea but with a string and hooks?

I'm happy to answer any questions and thankful for suggestions.


r/maker • • 18h ago

Help Help me make the diy stand better or replace it in cheaper options

Thumbnail
gallery
0 Upvotes

This is my DIY prototype for table/phone plus headphone stand but it has many issues like its not stable because the mold it base is not proper the rod that goes into the hole is not that grate looking because i have to stick mobile stand and kind of headphone stand on that rod through tape which doesn't look good and the white thing thats just cardboard covered with paper tape to hide and balance the black rod which carries the stands

You can also suggest me some products which can replace this whole stand