r/mr2 • u/gaming_squids • 2h ago
When i get this finished ill post the file for download
I aint a fan of people over pricing crap so imma lowball them
r/mr2 • u/gaming_squids • 2h ago
I aint a fan of people over pricing crap so imma lowball them
r/mr2 • u/TheM4Warrior • 4h ago
Hey all, My 1992 sw20 3sge sounds like it stutters and nearly stalls when revving in neutral after a cold start. It eventually goes away once the car is warm. Does anyone have any ideas? A mate suggested the igniter?
r/mr2 • u/skid_jesus • 6h ago
My sw20 is leaking through the Interieur lamps (t top) is there maybe a blocked channel or do I need new seals?
Thanks for your help:)
r/mr2 • u/Llewllyn • 1d ago
Im talking about the checkered/swatch like pattern in the center of the seats/on the door panel. I think this is a stock fabric from the 94/95 SW20. I’ve spent a few hours googling to try and find the answer but have had no success, google search really sucks now.
r/mr2 • u/Gullible_Try_414 • 1d ago
Hi guys,
Tl;dr: 93' MR2 electrical dash, tachometer reads 20-30km/h too much even after putting in new capacitors. Looking for Ideas what to look at next.
I'm having an issue with my 93' MR2 SW20. When I bought it, the dash had an issue with speedo and tachometer. After some research I put in new capacitors for speedo and tachometer. Tachometer now works fine, shows plausible values. However my Speedometer still has an issue. Since I have it, it shows about 20-30 km/h too much at every speed. However, it goes down to 0 when standing still, so it's not just a flat offset.
I'm thinking maybe changing speed sensor? But as far as I know, RPM should also come from the VSS sensor so if the sensor would be the issue, the RPM would be wrong too.
Could it be someone pulled off the needle and put it back on wrong? And if so, how can I place it correctly with the right tension?
Or could a different electrical component cause a issue where the speedo shows too much?
Open to any idea!
r/mr2 • u/Ongoingbrawl • 1d ago
Hey guys so my 5sfe is having an issue where ill attempt to accelerate after shifting gears it'll go into gear fine but ill give it gas and it just has lack of power for a little bit, and ill get like a rasping noise like an exhaust leak kinda deal but im more so wondering my flex pipe is cracked but that wouldnt impact my power would it?
r/mr2 • u/kareem613 • 1d ago
I posted about this a few months back. After a summer with it, I'm super happy with the setup. Phone holder is rock solid. Cup holder is great too, although I only used it once to be honest.
There were requests to share the files for 3D printing. They're up on makerworld along with the parts list.
Step files included if you want to make changes. The magsafe phone mount for example, can be easily swapped out for something else.
r/mr2 • u/Huge_Elk_7434 • 1d ago
I’ve bought a 1993 mr2 gt which has been sat for 13-14yrs, I’m wanting to take the fuel out of the car so I can put fresh petrol in before starting it up. I have seen siphon things but it looks like it can only put fuel in, instead of taking it out. I’m from the uk so anything that is available here thanks
I'm trying to install an EVAP canister from a gen 3 3SGTE in my 1993 USDM MR2 that was originally an N/A, but now has that motor. The old canister has 3 vacuum lines coming off of it, and is obvious how to connect. But the new one has 4.
It has this weird setup at the solenoid in the little hardlines where the one that goes from the bottom of the can tees off into another line. That line also has a little canister in-line (a check valve?).
I assume the larger bottom one and the top one go to the original lines that lead to the fuel tank, and that the non-tee-ed hardline from the top solenoid port goes to the intake manifold. I am at a loss for where the last tee-ed-off hardline with the little can goes. I can't think of anywhere it could go that would make sense to me.
I tried searching online, but can't seem to find out. Anyone have any insights? Maybe someone with a JDM MR2 that has a gen 3 stock?
Thanks!
r/mr2 • u/bigjohnstud • 2d ago
One last trip out before it's too cold in NE USA.
r/mr2 • u/nielsmittertreiner • 2d ago
Hey guys, my passenger sun visor got super loose and sometimes falls down when I go over a speed bump.
Is there a way to tighten this or can I kinda disassemble the sun visor without ruining it?
Any help would be appreciated!
r/mr2 • u/SimonThorsager • 3d ago
Looking for a short shifter for my 91 MR2,
but I can't make up my mind if i wanna go for the OEM 93+ or the C's / TRD Short Stroke Shifter from PrimeMR2.
Has anybode used the PrimeMR2 and how does it feel?
I've read that a lot of people prefer the 93+ since other short shifters can get too short.
I took my AW11 to a garage to get the coolant flushed and had a 5L bottle of premixed antifreeze, 5L bottle of concentrate, and 5L of distilled water in the trunk for them to use. When I went to collect the car they said they refilled using only the concentrate. I asked if that's okay and they said yes it's normal to run pure concentrate? I thought you were supposed to mix it 50/50 with distilled/deionised water?
When I drove back the revs were hunting a bit when idling and the temperature gauge went slightly above 50% (normally stops around 40% when fully warmed) but didn't go higher. I assume that's because the cooling system just needed time to settle or whatever after the flush. My idle RPMs were also around 800 which is weird because my car normally sits around 1200 when fully warmed. (My car has idle hunted + idled at 800 RPM in the past but that was because the radiator was nearly empty and I didn't realise until it overheated). I topped up the radiator the next day with distilled water and it stopped hunting + idle RPMs went back to around 1200.
Sorry if my explanation has been all over the place but basically my car acted the same way it did running pure concentrate as it did when the radiator was almost empty.
People online say idle RPM is supposed to be around 800 but when mine was there, if I put a bit of load on the alternator (such as trying to close the electric window when it's already fully closed) the revs would drop to around 500 and nearly stall.
r/mr2 • u/elhvywillywonka • 3d ago
What BOV/recirc valve are you guys running?
Mine is clicking constantly and seems to be acting up making the car run sluggish and unresponsive when installed. We removed it and the car suddenly started revving much more freely.
I’m looking at the BLITZ BOV but wanted to see what people run and if this is a good option.
What are you guys running?
I do small trivia books about specific cars, done Miata, S2000, Celica and a few others. MR2 is next, all three gens.
before it goes up on amazon I'd like to give the ebook free to a few people who actually know these cars. mostly so someone catches the stuff I get wrong before it's printed, mid engine Toyota history has a lot of half true forum lore.
no strings. if you end up liking it and want to leave an honest review when it's out, cool, if not also fine.
drop a comment and I'll message you when it's ready. probably a few weeks out.
(asked the mods first, they said go for it)
EDIT: way more replies than I expected, thank you. everyone who commented is on the list, I'll DM you when the ebook is ready. and keep the corrections coming, the 1ZZ oil burning thread below is exactly what I was hoping for
r/mr2 • u/Fattymeatsticks • 4d ago
Does anyone know how to fix/adjust this little compartment. Can't seem to find anything on it. When I got it back from the body shop some time ago, seems like they broke it and had it closed but it won't stay closed just flops and is really loose. (SW20 chassis)
r/mr2 • u/Corrupted-file • 4d ago
Finally got the brackets I made last month, and they look gooood! Still need to find a pipe to fit over these so I can mount a bike rack. Got the inspiration from the BRZ bike mount and decided to make my own, although way cheaper and perhaps even stronger? 😂
r/mr2 • u/elsquirrelz • 5d ago
Was trying to make a before and after video for when i switch to LED headlights next month, but the rain kinda ruined the video.... Still chill though.