I think it’s important for me to make this post, mainly because it’s a well known issue and most forums and posts around this issue haven’t mentioned this easy cheap solution,
As you can see from the first image, my whole bumper bracket/clip pretty much snapped off completely clean
After looking at posts and forums and asking around, people would always say to drill a hole and make a quick release, but in my humble opinion I’d rather avoid making holes in my bumper at all cost
People would also mention just buying a whole new bumper which if you go this route I highly advise you to calculate the costs before doing any decision (actually buying it, painting it, clear coat, paint match, install, tabs, like new mounts, unless you do all this yourself but in my humble opinion (again) I think it’s best to have a professional do this kind of work instead of a shabby job, no hate to those who do attempt it)
Now after searching online for months I stumbled onto this post on Facebook by chance and saw this company that’s similar to maclifters but they actually make the piece I needed for my car
This company is called JT Spec, they have almost infinite models to choose from, the install is fairly straight forward, just make sure to have clamps, and to use the recommended binder, make sure to also pay attention to your mounts that are on the car to make sure none of the pins aren’t broken (also even more important but pretty relevant, make sure to have it properly set in place, once bonded it needs to fit exactly like the original, I won’t be posting links but if you put JT spec in your search bar, you’ll find it
As for the glue I found it at my local hardware store, and for the broken mounts I had, instead of getting them from Hyundai I went on Amazon and bought some for 20$ (the turbo and non turbo are the same for this), I will say that the one I got from Amazon, the white pins that keep the mount held in (even tho you have screws added) were a little different but I can confirm the stock white pins fit perfectly into that mount, not you will have to drill a small hole into the Amazon mount for the screw entry point, but that’s simple just put in the white pins, you’ll see a hole on the top of the factory pins, and just find a bit that fits into it and drill
If you’re problem was like mine, there wasn’t much need to remove the hole bumper it can be stretched without any damage, it take about 2 hours to fully cure (I know crazy) but it’s actually really solid, once dry just follow the steps of fitting back your whee liner into the bumper, push the bumper in, then put the final screw that goes in the top well
I can highly confirm it’s really easy, just make sure to have some basic tools, be prepped, and be careful, the final result is basically indistinguishable from factory look, and it’s more solid than factory, I will also add the the website say to use the factory clips alongside it but, in all honesty you really don’t need to since it’s the same holes and fit/size, aslong as it’s in the same place as the original, it will work, keep in mind if you’re hesitant, it’s worth a shot than buying a new bumper or having irreversible damage, and the cost is less in the long run
I’m not responsible for any actions you decide to make from my post, take it as you will, and do so at your own risk, feel free to message me if any questions come to mind