r/BmwTech • • 12h ago

Do Chinese aftermarket BWM "VDC/EDC" struts actually have working variable damping valves, or are they just passive dampers with a resistor bypass?

1 Upvotes

​Real variable valve vs. resistor trick: Do any of these Chinese BMW G32/G11 air struts actually replicate ZF’s continuously variable proportional solenoid valve (so Comfort vs. Sport mode genuinely changes valving), or do they just use a fixed passive shock with an internal resistor to prevent chassis/VDC fault codes?? ​Has anyone mixed one Chinese "VDC" strut with a factory ZF VDC strut on the opposite side of the same axle? If the Chinese one is actually passive, I'm assuming it would cause uneven rebound/compression side-to-side


r/BmwTech • • 11h ago

Help getting idrive controller harness wiring fre

Thumbnail
gallery
1 Upvotes

Does anyone know tips to get the red wiring from the back of the idrive console out? I literally cannot get it to budge


r/BmwTech • • 41m ago

Gasket Placement/ Cold start issue

Post image
2 Upvotes

For the past 2 years I’ve been doing my own oil change, on my 2016 535i and have been having this annoying cold start delay it only lasts between 3-7 seconds and starts up easily no check engine noise codes, I was told it could be sometimes oil pressure is t well built, MY question is could it be my fault? I just realized that I’ve been putting the gasket in the red arrow could that be it????


r/BmwTech • • 4h ago

In need of advice

Thumbnail
gallery
2 Upvotes

Hi all, gonna need your advice on the following. I know it's almost impossible to tell without looking further into the engine and reading codes etc. but could this be because of excessive blowby? When I take the oil cap off it has some steam coming out, but wouldn't say it's massive. Would you run away from this or am I worrying too much? Otherwise the engine runs sweet and the exhaust smoke isn't oily or excessive. Anything you'd recommend to have a look into? Kinda new to the game. It's a N53B30U0 325i btw. Thanks in advance


r/BmwTech • • 17h ago

BMW e46 ignition issue (HELP PLEASEEEEE)

0 Upvotes

BMW e46 330ci 2004 convertible does not start after trying to wire a flame kit(yes I know I’m a idiot)
After wiring it in the spark plug works fine but then does not turn over anymore
We removed the flame kit and brought it back to original but doesn’t even turn over now

Here’s what happens
- everything turns on
- fuel pump engages
- lots of clicks
- mostly a lot of jack shit

What I’ve done
- checked fuses
- checked lines
- checked continuity and voltage on most lines and battery


r/BmwTech • • 20h ago

2023 26k Mile BMW B48B20A 320i Low Oil Level only 5k miles after last oil change?

Post image
2 Upvotes

Got an interim oil change done at my local BMW dealership at 20500 miles, I had no oil warning from 13k miles up until that point with arguably even heavier driving and now I’m at 26k miles I have this oil warning just over 2 months after my last oil change?

Is this a cause for concern surely a healthy B48 shouldn’t burning oil at this rate?

I have some wastegate rattle on cold start for about 2-5 mins then dissapears could that be an issue? That’s being looked at in 2 weeks but I just can’t get my head around it burning through a litre of oil at 5k miles being such low mileage.


r/BmwTech • • 20h ago

Tyre size / wear on xDrive ?

Post image
2 Upvotes

Hey everyone !
I just bought an E91 LCI xDrive and it got 4 tyres in 225/40 R18 same brand same wear at the moment.
But this size is not permitted on the rear axle so I’m looking to put new tyres that will also fit my rims.
Now my question is, what’s the rule with xDrive ?

Some say 1% other say 2mm thread, I’m a bit lost and I don’t want to damage my transfer case.

I can get some second hand tyres in 225/40 R18 (front) and 255/35 R18 (back) same brand with 0,5mm of difference in tyre wear, no problem with that ?
Thanks for your help and expertise.


r/BmwTech • • 19h ago

G12 750 - Stalled suddenly, won't run - Help?

Thumbnail
gallery
3 Upvotes

So I didn't even make it out of my driveway before my car just ... Sort of died on me. I felt a sort of rear end shudder, then it popped up a "gearbox in neutral" warning as it shut off. Nothing else. The first time I tried to restart it, it cranked and ran for a couple of seconds before the above happened again. Right now, it'll crank, appear to start, then immediately silently die. No codes appear to have been stored in OBD2, nor in the iDrive vehicle status. While I'm a little overdue for an oil change by time, I'm not by mileage. So, before I call AAA to drag this back down my driveway since I'm blocking it, or to my shop to be checked on this weekend... Any ideas?


r/BmwTech • • 18h ago

Is this N55 cooked

5 Upvotes

After fixing a misfire issue involving the intake it seems to make a loud tapping sound coming from the top. No idea.


r/BmwTech • • 16h ago

N55 Valve cover replacement question

Thumbnail
gallery
4 Upvotes

The new replacement came it & noticed that the Clip-on cap for the pcv is off. I clipped it back on, but it slips off with just a teeny bit of pressure. Seems the 2 clips were molded inwards a lil. Do I get a refund or is there a way to fix it? Everything else is in perfect condition with no issues)


r/BmwTech • • 20h ago

Does the engine sounds normal? N47 e92 130kw

2 Upvotes