r/Fixxit • • 36m ago

My 2020 Beta RR 125 doesn't run correctly anymore!

1 Upvotes

Hi everyone,

I’m trying to track down an issue with my Beta RR 125. I took it out for a ride, shut it off normally, and the next day it wouldn’t start. I checked the plug and found I had no spark.

I traced the problem back to the CDI and bought a replacement. With the new CDI, I have spark and the bike starts, but it barely idles. As soon as I crack the throttle, the engine cuts out instantly. If I put the old CDI back in, I lose spark again.

I’ve also tried a new stator and a new ignition coil. With the replacement CDI fitted, the symptoms are exactly the same. I’ve checked the carb and it’s clean, the engine has compression, and the reeds look fine.

One other thing I noticed is that it only starts with the choke plunger down. If I lift the plunger while it’s idling, it dies immediately, just like it does when I open the throttle.

Has anyone run into this on an RR 125? What would you check next?

Thanks for any pointers!


r/Fixxit • • 2h ago

Duke 390 (2021) Not Starting

1 Upvotes

KTM Duke 390 2021 Europe


r/Fixxit • • 6h ago

Unsolved 2004 Honda Rebel 250, No Spark

1 Upvotes

I got a free project bike with unknown history and haven’t been able to diagnose my no-spark issue. It’s a 2004 Honda Rebel CMX250C.

I have very little info on this bike, but it seems to be in decent condition. All my electronics work, lights, signals, and it cranks healthy. Battery is good too.

I’m not great with the multimeter, but I checked a few things, like the kill switch and kickstand safety switch, and couldn’t figure out my issue.

Here’s what I’ve measured so far:

Stator/exciter coil (black/red wire): ~65V AC while cranking
Pulse generator: ~111 ohms and 0.35V AC while cranking
Ignition coil primaries: ~0.2 ohms each
Ignition coil secondaries: ~8.61k ohms, similar on both
CDI ground: Continuity to ground
Kill switch: tested and ruled out
Kickstand switch: Continuity to ground with stand up, none with it down
Black/yellow CDI output wire: ~1.1 ohms to ground with CDI unplugged and coils still connected

The CDI was a red one from 2015, and said it was for a Nighthawk. This bike never sparked when I got it, so I replaced that with a cheap eBay CDI for the Rebel and still no spark in either plug, still.

I got a peak voltage adapter to allow me to check the CDI, but I really don’t know what any of these multimeter tests are telling me, honestly. I’m not even sure what I’ve ruled out at this point.


r/Fixxit • • 14h ago

1999 yz80 Yamaha

Thumbnail reddit.com
1 Upvotes

r/Fixxit • • 14h ago

1999 yz80 Yamaha

1 Upvotes

I need some advise on my bike . I already replaced the carburater, cylinder, and the piston. And it still won't start. any ideas??????


r/Fixxit • • 14h ago

Bike restoration questions - 2001 Suzuki LS650P Savage

Thumbnail reddit.com
1 Upvotes

r/Fixxit • • 19h ago

Tail light only works when breaking

Thumbnail reddit.com
0 Upvotes

r/Fixxit • • 23h ago

Speedometer isn't working and the abs indicator and tcs indicator remains on any solutions? Yamaha xsr 155 it's been 2 weeks since I bought it

Thumbnail gallery
0 Upvotes

r/Fixxit • • 1d ago

Problema accensione Low Rider S Fxlrs

0 Upvotes

Buongiorno, ho un problema di accensione, dove la mia moto parte solo con il secondo avviamento. Non lo fa sempre, solo a volte, dopo averla lasciata spenta qualche ora. Il mio meccanico ha già sostituito i gommini della pompa benzina ed ho sempre acceso la moto in folle con cavalletto alzato, in modo da escludere problemi al sensore cavalletto. Qualcuno sa aiutarmi?

Low Rider S Fxlrs del 2022 117


r/Fixxit • • 1d ago

Solved Honda Phantom TA200 Year 2005 make clicking noise

1 Upvotes

r/Fixxit • • 1d ago

Triumph Speed T4 suddenly switched off while riding – won't start now, only a single clicking sound

Thumbnail reddit.com
0 Upvotes

r/Fixxit • • 1d ago

Unsolved Let's Raise a Joint Complaint Regarding the Rear Brake Issue

Thumbnail reddit.com
0 Upvotes

Hi fellow XSR 155 owners!

I'm facing an issue with the rear brake(REAR brake getting loose and no braking power at all, apparently something to do with the master cylinder), and apparently, several other owners are experiencing the same problem.

The service centre has indicated that the issue is with the rear brake master cylinder. They have suggested replacing it with a master cylinder from another model, which would cost approximately ₹2,500.

Currently they are giving temporary resolution by brake bleeding process but it comes back in a few days only. Which is unacceptable

However, considering that multiple owners are reporting the same issue, this seems to be a potential widespread manufacturing or design-related problem rather than individual wear and tear. We believe Yamaha should take responsibility and provide a free replacement or permanent resolution under warranty, rather than charging customers for it.

I'm planning to write a formal email to Yamaha highlighting the issue. If their response is unsatisfactory or they fail to provide a proper resolution, we can consider filing a joint complaint with the Consumer Forum.

If you're an XSR 155 owner facing the same rear brake issue, let's collaborate!

Please DM me your email ID so I can include you in the email to Yamaha. The more affected owners who come together, the stronger our case will be.

Let's get Yamaha to acknowledge and resolve this issue!


r/Fixxit • • 1d ago

Unsolved need help analyzing tire wear on left side

1 Upvotes

https://imgur.com/a/gdGxe9F

https://postimg.cc/gallery/MM5YTR1

last 3 tires im getting a concave surface with heavy tread wear in the left 1/3 of the tire having me change the tire before the middle reaches its service interval.

im wondering of its the left shock dropping and thus the tire is scraping on the botton left side of the engine crankcase?

I just have no idea whats happening. it doesnt have its center stand and only use left side stand so maybe wear leaning on that side? it didnt do it prior to the last 3 tires Ive had and different tires were used. pirelli /pirelli /dunlop

sym maxsym 600cc


r/Fixxit • • 1d ago

Bought a "dead" 2008 KLR650 for $400. Water pump shaft threads are gone. Gen 2 balancer shaft removal question

Thumbnail
reddit.com
1 Upvotes

r/Fixxit • • 2d ago

Repair help?

Post image
1 Upvotes

r/Fixxit • • 2d ago

Unsolved Jawa Perak (2022–23) keeps stalling when slowing down or braking. Any ideas?

1 Upvotes

Hey everyone!

I own a Jawa Perak (2022–23 model), and I’ve been facing a strange issue with the engine shutting off.

Here’s what happens:

The bike starts normally and idles fine in neutral.
After riding for about 1–2 minutes, whenever I slow down, apply the brakes, and pull the clutch, the engine silently shuts off just before the bike comes to a complete stop.

For example, if I’m riding at 50–60 km/h and see a red light, I start braking and downshifting. With the clutch pulled in and no throttle, the engine suddenly dies.
However, if I keep giving it a little throttle while holding the clutch, the engine doesn’t shut off.

This only happens when the engine is cold sometimes in hot too. But usually initially under 1-3 mins.

It has never stalled while riding at higher speeds.

Starting issue:
When the engine stalls, it usually takes around 2–3 attempts to restart while in gear (the starter cranks, but the engine doesn’t fire). However, it generally starts on the first attempt in neutral.

Another issue — possible clutch slipping:

My clutch plates are somewhat worn out. I’ve also noticed a loss of acceleration and torque compared to when the bike was new. If I suddenly give full throttle, the RPM shoots up, but the bike doesn’t accelerate accordingly. Gradual acceleration works fine.

What I’ve tried:

The check-engine light was previously on, so I took the bike to the authorised service centre. They replaced the ECU, and the warning light disappeared, but the stalling issue remained exactly the same.

My questions:

Could this be an issue with the throttle body, idle control, or fuel supply when the engine is cold?
Could worn clutch plates or incorrect clutch adjustment cause this?

Has anyone experienced something similar with their Jawa Perak, Jawa 42, or other Jawa motorcycles? If so, what fixed it?

I’d really appreciate any suggestions before I take it back to the service centre. I don’t want to keep replacing expensive parts without finding the actual problem.

Thanks in advance!


r/Fixxit • • 2d ago

2016 Honda crf 230 issues

1 Upvotes

Hello, I am having issues with my dirtbike I’m not too sure how to describe it but I’ll try my best. I bought a new kill switch for my bike, before I switched it the starter worked perfectly fine, even when the kill switch was completely off it still ran, but ever since I connected the new kill switch the starter just does not work atall, not even a little and the battery is new. The part I don’t get is everytime I press the new kill switch the fuse cracks but I want to figure out how to get my bike working again, if anyone out that can help it would greatly be appreciated!


r/Fixxit • • 2d ago

Check engine Light 650Twins

Post image
2 Upvotes

r/Fixxit • • 2d ago

Does this 09 rmz450 sound healthy?

2 Upvotes

r/Fixxit • • 2d ago

Help with 86 Suzuki Savage ls650

Thumbnail gallery
5 Upvotes

r/Fixxit • • 2d ago

2006 Honda cbr 1000rr does it sound like the bottom end is going to give out?

4 Upvotes

Does anything sound wrong with the motor? I’m hearing a vibrating sound or a humming sound is the best way to explain it


r/Fixxit • • 3d ago

Unsolved 2009 Husqvarna WR 125 2-stroke lost power, died and won’t restart

1 Upvotes

While riding, my WR 125 gradually lost power and eventually shut off. The rear wheel didn’t lock up. Now it won’t start, and sometimes it makes a popping sound when I try to kick-start it. I might have left the choke on during the ride. Could that have fouled the spark plug? What should I check first?


r/Fixxit • • 3d ago

Exhaust discolouration, Should I be concerned?

Thumbnail reddit.com
1 Upvotes

Yamaha XSR700 2016

Just cautious, Video of how exhaust looks in the comments. Thanks!