So here’s everything that I’ve done that I remember, it’s a 1996 f250 7.5l
New alternator,
new MAP sensor,
new pumps,
new cap and rotor on the distributor,
new battery,
cleaned out the fuel lines,
completely removed the intake manifold and cleaned it,
cleaned the injectors
has good fuel in it,
new fuel pump fuse,
tested the fuel pump relay,
tested the pcm diode,
pulled the ecm and checked for bad traces and leaking capacitors,
ran a jumper wire straight to the pump,
I have spark and I have compression and it will run on starting fluid but will die the second I touch the gas and I have 6.7 ish volts at the tank selector switch and the same at the pump with key on with it cranking I only have 5.5 ish volts to the pump, I have 30 psi exactly at the fuel rail, I still can’t get it to run on its own, any other ideas?