r/Ford • • 11h ago

Show Off 📷 Stoked how the supercab ranger turned out 🤙

Thumbnail
gallery
68 Upvotes

Methods on Maxxis tyres, lift on the front and flares


r/Ford • • 17h ago

Show Off 📷 Shelby GT350 🆚 ZL1, Stock vs Stock, Street tires, 1/4 mile drag race

29 Upvotes

r/Ford • • 17h ago

Show Off 📷 Extended cab long bed is the best cab and box configuration, change my mind

Thumbnail
gallery
7 Upvotes
  1. Extended cab long bed. Full size bed and decent amount of room in the cab. Can still fit in a standard parking space
  2. Crew cab long bed dually, still turns okay, more room in the cab compared to extended cab, but cannot fit in a standard space
  3. Tie between extended cab short bed and single cab long bed. They both usually ride worse compared to 1&2, but they are easier to drive around town, especially if you’re letting someone who has never driven a pickup around use it. My next truck will probably be a single cab long bed.
  4. Crew cab short bed, I just don’t find myself using it that often. Decent for towing goosenecks, but I would rather use the extended cab compared to it.
  5. Crew cab long bed, single rear wheel. Turning circle is way too wide. I had one once, never again.
  6. Crew cab extra short bed, if I still hunted with hounds I would get one, but that’s the only reason I see for me to get one.

Speaking as a horse trainer and cattle farmer. That’s my current fleet of fords.


r/Ford • • 7h ago

Question ❔ How bad is this fault?

Thumbnail
gallery
3 Upvotes

r/Ford • • 18h ago

Issue ⚠️ Crank no start and no idea

3 Upvotes

So here’s everything that I’ve done that I remember, it’s a 1996 f250 7.5l

New alternator,
new MAP sensor,
new pumps,
new cap and rotor on the distributor,
new battery,
cleaned out the fuel lines,
completely removed the intake manifold and cleaned it,
cleaned the injectors
has good fuel in it,
new fuel pump fuse,
tested the fuel pump relay,
tested the pcm diode,
pulled the ecm and checked for bad traces and leaking capacitors,
ran a jumper wire straight to the pump,
I have spark and I have compression and it will run on starting fluid but will die the second I touch the gas and I have 6.7 ish volts at the tank selector switch and the same at the pump with key on with it cranking I only have 5.5 ish volts to the pump, I have 30 psi exactly at the fuel rail, I still can’t get it to run on its own, any other ideas?


r/Ford • • 1h ago

Review 📝 4000KM ODO Update: Everest Platinum V6 3.0 with DEF (AdBlue) [Philippines]

Post image
2 Upvotes
1. Did PMS at 2K (oil change). They added engine additives which are NOT recommended by the manual, so I’ll tell them not to do it next time. Basically burned extra money. Still a good call to get the oil changed though.

2. It has DEF, so it’s not designed for long idling. Avoid idling for long periods. The start/stop does wonders when you’re stuck in traffic. It’s on by default when you start the car (annoying), but there’s a dedicated button to turn it off.

3. The DEF system does require regen if you only do stop-and-go driving, but if you take it on the expressway and do long TPLEX trips, it’s fine.

4. Handling is amazing. It’s stable on tight corners and climbs anything you throw at it. The tires are road-only and they’re great for that. I haven’t done any real off-road yet — the current wheels don’t have enough sidewall, so that would be pushing it.

5. Fuel consumption isn’t bad: 8.2–11 L/100 km. It really depends on how you drive. Best to use 2H ECO in city traffic and 4A on the expressway. Wouldn’t recommend staying in ECO all the time.

6. I use V-Power. I used FuelSafe before until I learned about the CP4.2 fuel pump and how freaking picky it is with fuel quality. I picked two busy stations and only fill from them now. Super important to choose the right stations.

7. Max range is 700 km+, but the numbers drop fast once you start driving. The car excels at fast driving and heavy pulls.

8. After long city sessions, I highly suggest doing a manual DEF regen: 10–15 minutes of steady driving in manual at 2.0–2.4k RPM and 90–100 km/h. Keep the speed consistent so it can build heat. This helps avoid extra regen cycles.

9. Don’t add extra fuel additives. V-Power already has them — no need to add more.

10. Make sure you keep AdBlue refills on hand. My brand (Clark) only had one bottle left (₱1,300). I’ll need to buy more soon. No AdBlue and you’re screwed lol.

I’ve done many long trips in it and mostly use it for intercity driving. I switched back to the Vios for pure city use — short trips just don’t suit this car. It loves being driven hard and is built for towing. The V6 is made for this.

Drive it like you stole it. You can always cry about the fuel later.

In the end: 10/10. Love it.

r/Ford • • 1h ago

Question ❔ '18 f150 gen 3 5.0L cam bolts

2 Upvotes

Hello, does anyone know what size bolts I need for cam shaft bearings and phasers for the 2018 gen 3 5.0L coyote?

Apparently they are all TTY bolts, but I cannot find a kit/set (arp apparently is for gen 1 an 2, even though they have all the years). And from what I'm finding online is contradicting.

If you know of a set or link for these with some type of expedited shipping I would be forever grateful. I need to get this truck going sooner than later. Kcmo area

ΤΙΑ


r/Ford • • 3h ago

Issue ⚠️ Fuel pump rusted

2 Upvotes

is there a way to rip it out or something i can’t get it off tried everything already


r/Ford • • 4h ago

Issue ⚠️ How to pop the hood of a 2013 taurus

2 Upvotes

Hey everyone this morning I was leaving for work and my car was completely dead. Wouldnt unlock and the back up key in the fob isn't the right one for it.

Does anyone have any suggestions or ways to pop the hood of the car from the outside so I can get a new battery in it. Thanks in advance


r/Ford • • 2h ago

Question ❔ 2005 6.0 question

Thumbnail
gallery
1 Upvotes

I replaced the head gasket on an old 6.0 that had blown. I’m putting it back together now. I have been following atomic diesel on YouTube very closely. I have the cab back on the body.
However, along the lines of the repair I had broke a few high pressure metal lines. Both due to negligence and rotting. I broke
-1 of the 4 brake lines coming from the master cylinder.
-both lines connecting to the power steering connection assembly (the two 18-19mm lines connecting to the main)

My question would be, can I leave those disconnected just to see if the engine will turn over and run? I don’t imagine I need brakes or power steering to turn over right?
Or, better yet, what would be the bare minimum I need to reconnect just to see if the motor would turn over and on.
If I know the engine works, I don’t mind buying brand new parts, but I’d hate to purchase them all just to realize the engine is toast. This is a farm truck so its outcome matters none to me. This is just a project. I’m working on with my father. Was his old truck, he got a new.

2005 350 super duty 4door 8ft bed…. Insanely rusty


r/Ford • • 5h ago

Issue ⚠️ Back control AC issues or touchscreen

1 Upvotes

2026 ford explorer active

I am experiencing problems with my AC and touchscreen. The front controls function well, allowing me to switch the system on and off, but the rear controls reset to level one whenever I attempt adjustment. Has anyone encountered comparable issues?


r/Ford • • 13h ago

Question ❔ Buying my first Ford

1 Upvotes

Hey, i wanna get my first car and looking at the options in the market and the price i find Ford the closest one rn (i dont really like asian cars) and ideally id like to get a used SUV (30-40k miles) but most of the comments about late gen Edge Escape or Explorer are pretty pessimistic in terms of reliability and EcoBoost engine. Can someone with these cars actually explain if these cases are truth or it’s just Reddit people saying usual stuff ?


r/Ford • • 15h ago

Question ❔ I accidentally hit a curb. Do I have to replace the rim as well?

Post image
1 Upvotes

r/Ford • • 20h ago

Question ❔ I really hope its just the brakes dragging

1 Upvotes

This is the only wheel that makes this sound. It is notnas loud in person

The sound goes away when i hit the brakes and does not change pitch when i transfer weight from side to side.

It is brake system or wheel bearing?


r/Ford • • 17h ago

Question ❔ What did you name your truck and how did it happen?

0 Upvotes

Ours is Bertha. My husband named her years ago and it stuck so hard that the kids and half the neighbors use it now. I catch myself saying it in public like everyone knows who I mean.

So how did yours get its name? A plate, a kid's idea, something the truck did on a bad day?