Hi, I just wanted to share my experience fixing the ribbon cable issues with my x5 lite and I hope it helps some other people with it since it seems like a common issue.
My x5 lite recently started having issues connecting after having it for 6 months. From reading here, it was clear the problem was with the ribbon cable. I’ve had a bit of experience repairing my old gameboy advance and DS lite so I decided to crack it open and have a look, worst case scenario, I would break it more but since it wasn’t working anymore, I figured why not?
Once open, I tested the ribbon cable and indeed one of the data lines was broken. I also saw the pads on the FPC connector were exposed so I decided to use some 30AWG wire in place of the delicate flat ribbon cable and solder directly to the solder pads. I cut up the existing FPC connector to make it easier to desolder as I don’t have a hot air station, and soldered the wire directly to the pads, following the ribbon cable connections. I deliberately made it a bit longer than the ribbon cable so that it has more leeway when plugging it in. After cleaning up the flux, I used a hot glue gun and dabbed some hot glue on the connections to protect it from being torn off again, I put more hot glue on the usb connector as I had to cut it up to expose the board on the usb connector and wrapped the wires in some electrical tape. I also removed the spring under the connector so that I can pull and push the usb connector in and out of the hole easier without using any force.
Now it works again and I just plug the usb connector in before opening the controller to fit my phone and iPad and push the connector into the recessed hole.
Sorry I didn’t take more pictures of the repair itself, my soldering skills isn’t that great (I ended up ripping a few pads when removing the FPC connector, which is totally optional, but I wanted a cleaner repair. I fixed it with some shoddy trace repair). It was also getting very late and I wanted to finish up and go to bed.