Loosing my mind trying to diagnose this, I should have listened to the reviews! Posting here in a last ditch effort before I return them
Below is an AI overview of what I’ve tried to do to fix an issue with my full setup via HomeKit, any advice would appreciated. I’m pretty close to returning every device and looking for another solution
My IKEA lights worked fine for two weeks, then broke last night, with lights, sensors and switches showing as no response or showing available, but turning them on or off via HomeKit did nothing
I rebooted the router and the Apple TV and randomly, an hour later, they worked. This morning they were broken again. After a couple more reboots I got another hour out of them, and now they’re broken again.
I’ve got 30 KAJPLATS bulbs (16 GU10s, 8 E14s and 6 E27s), plus IKEA sensors and remotes. My only Apple Home hub is a wired Apple TV 4K (3rd gen, or latest version) wired to an eero Pro 6E. Thread is off on the eero. The Apple TV runs Thread on channel 25. I’ve also tried setting the Apple TV to WiFi.
Some bulbs show No Response, others look online but do nothing when I tap them, then change minutes later. This happens across different rooms, even when I’m just turning one bulb on or off.
I spent hours on this with ChatGPT. I ran network tests from my Mac and pulled several Apple TV sysdiagnoses for it to compare. Even during an outage, the Mac could still see the Thread border router over Bonjour and two of the affected GU10s answered all five IPv6 pings each.
The TV logs showed 63 Matter discovery timeouts across 22 IKEA devices after a restart. Some commands sat in the Apple TV’s queue for 5–9 minutes before it even sent them. One GU10 ignored four retries on an old Matter session, then answered in 293 ms on a fresh one.
The temperature sensors were timing out too, so I wondered if a sensor or remote was causing trouble on the mesh. I took the batteries out of every one of them. After a reboot the lights recovered for a bit, then the whole thing broke again with the batteries still out. I also tried leaving the 16 GU10s off at the wall for ten minutes.
I’m pretty much done troubleshooting and looking at returning the lot. Posting here as a last ditch effort:
Has anyone seen this and found a fix that stuck?