Quick update on the 1996 JDM DC2 Type R build (RHD, AWD managed by FuelTech FT600).
The original wiring plan called for two commercial 35-channel PDMs, one for the engine bay and one for the body. The more I worked through the harness, the less I liked it: two boxes, two sets of power, ground and CAN, and more wire than the car needs. So we designed our own. We call it PDM86, a Blacksite Motorsports inspired digital 86-channel PDM built for full vehicle integration on this car.
WHAT IT IS
A PDM (power distribution module) replaces the fuse box and relays with solid-state switching. Every circuit is switched, monitored and protected electronically. No fuses to blow, no relays to fail, and every output reports what it is doing. PDM86 combines the I/O of both of the original units into one flat, sealed, black anodized aluminum case with no fans. The 86 is the I/O count.
WHAT IT DOES IN THIS CAR
It runs the whole body side of the car. It is the body control module as well as the power distribution, so lighting, turn signals, hazards, power windows and mirrors all go through it over CAN. For example, the brake lights are driven by the PDM from the brake inputs, not by a switch wired straight to the bulbs. It drives the three fuel pumps. The FT600 sends a PWM signal to the PDM, and the PDM drives the pumps. They sit in a Radium sump in the trunk and feed forward through bulkhead passthroughs.
It talks to the FT600, the CAN steering wheel and the electric power steering. It reads chassis sensors: ride height at each corner, plus brake rotor and caliper temperatures. It powers the water-methanol system in the rear. It goes into a very low power state with the key off, so the car can sit without draining the battery. It has Bluetooth for live status and the fault log. It is read-only by design. Nothing on the car can be switched from a phone, and settings can only be changed with the car parked.
A FEW DESIGN CHOICES I CARE ABOUT
ABS stays its own independent system. The PDM does not get a vote on braking, and steering assist keeps its own authority too.
Every output defaults to off. The firmware has to decide to turn something on. The engine harness and the body harness are separate. The FT600 lives in the driver's side of the dash with the engine harness running out from there. PDM86 mounts behind the passenger seat, and the body harness distributes from that point along the tunnel and sills, clear of the roll cage. We 3D scanned the body shell and are using the scan to lay out the harness and get wire lengths right before anything is cut.
WHERE IT STANDS
The board layout is being finished for the first prototype run, and the case design is done alongside it. It still has to go through bench and thermal testing before it goes in the car, so this is a design update, not a finished part. I'll post more as the prototype comes together.
Happy to talk through the design thinking. Has anyone else here run a PDM in a DC2, and what would you do differently?