r/SolarDIY • u/darksamus8 • 10h ago
Custom Solar Ground Mount on Granite Boulder
3x 430W REC panels, 1x NEP BDM 1200-LV 120V plug-in microinverter. I just finished this yesterday, I do not have any production numbers (believe me, I'm more disappointed than any of you 😅)
Title says it all. My parents house has this weird ledge of granite that's a super awkward shape on a steep hill. It's always been in the way. No grass. Could never plant anything on it. Only moss grows. Even just decorating it has always been a colossal PITA. So I finally decided you know what, I'm gonna build a ground mount on it. It gets sun ALLL day during the summer, and my parents have these big pumps for their pond. Why not get some solar 😎
Bought a cheap rotary hammer and went to town. I demo'd the granite until I hit solid rock, drilled holes and installed 1/2" threaded rods as anchors w/ Sika Anchorfix 2, two rods per footer, ~6" deep minimum. Some of the granite was REALLY badly weathered so I had to demo down over a foot just to get solid stone. I hit it eventually. I also hammered into and flattened the areas as best as I could and lined them all up.
Then, I installed very stiff rubber pads so the footers would have something to help keep them level, and wouldn't sit in any standing water. I also carved channels to drive any water away.
I started with my 3 front footers and and cut strut so the heights would be all exactly the same, true horizontal. Then, I measured and cut all the strut for the rear footers, to connect to the front ones at a 35 degree angle. I had calculated 36-39 degrees was optimal for the latitude (New England) and the azimuth (about 220 degrees), but 35 is what I could achieve consistently with the amount of strut I had. This was really tough for the angled footers, since the connection was free to move around. All the support pairs were 35±0.4 degrees. Considering how absurdly uneven the rock was to start, I'll take it.
Once I had all the front-rear pairings done, the hard work was over. Laid strut across for the full length of the panels, leveled with a laser, and then then panels followed soon after. Attached the inverter to the back, and wired it all up.
It came out SUPER clean, I'm very happy with it. My wife encouraged me to share it with you nerds.
Also, I powered the my little jobsite with my car 😁