Sorry if this is easily searchable but I'm not the one who initially set up the printer, my sister did, so I missed out on a lot of the learning experience. They rooted it and installed Klipper and Guppyscreen, etc. At one point the hot end was replaced too.
Ender 3 v3 KE, so it doesn't have bed level adjustment knobs, which is what I'm mostly finding in my search results.
Is this normal? When running the bed level calibration it is pushing down so hard on the bed it's moving. Also for the first row the print head is hanging over the front of the bed. This doesn't seem right to me and also the results of the calibration show the front row is higher than the rest of the bed - it seems like that would be because its pushing down while measuring the rest of it.
I tried running the z offset and z compensate tests, as well as manually setting the z offset crazy high like 50 and it didn't change.
I was considering resetting the firmware and starting over but I wanted to find out if it's a hardware problem or something easily fixable first. Thanks!