r/Fixxit • u/BusinessCharge3818 • 7h ago
r/Fixxit • u/BusinessCharge3818 • 7h ago
1999 yz80 Yamaha
I need some advise on my bike . I already replaced the carburater, cylinder, and the piston. And it still won't start. any ideas??????
r/Fixxit • u/Cool-Bend8931 • 8h ago
Bike restoration questions - 2001 Suzuki LS650P Savage
reddit.comr/Fixxit • u/Heavy-Lengthiness831 • 12h ago
Tail light only works when breaking
reddit.comr/Fixxit • u/Imaginary_Block8867 • 16h ago
Speedometer isn't working and the abs indicator and tcs indicator remains on any solutions? Yamaha xsr 155 it's been 2 weeks since I bought it
galleryr/Fixxit • u/thezarpe • 19h ago
Problema accensione Low Rider S Fxlrs
Buongiorno, ho un problema di accensione, dove la mia moto parte solo con il secondo avviamento. Non lo fa sempre, solo a volte, dopo averla lasciata spenta qualche ora. Il mio meccanico ha già sostituito i gommini della pompa benzina ed ho sempre acceso la moto in folle con cavalletto alzato, in modo da escludere problemi al sensore cavalletto. Qualcuno sa aiutarmi?
Low Rider S Fxlrs del 2022 117
r/Fixxit • u/Ok_Simple_1040 • 21h ago
Solved Honda Phantom TA200 Year 2005 make clicking noise
r/Fixxit • u/SingerNo4167 • 22h ago
Triumph Speed T4 suddenly switched off while riding – won't start now, only a single clicking sound
reddit.comr/Fixxit • u/dabek69 • 23h ago
Unsolved Let's Raise a Joint Complaint Regarding the Rear Brake Issue
reddit.comHi fellow XSR 155 owners!
I'm facing an issue with the rear brake(REAR brake getting loose and no braking power at all, apparently something to do with the master cylinder), and apparently, several other owners are experiencing the same problem.
The service centre has indicated that the issue is with the rear brake master cylinder. They have suggested replacing it with a master cylinder from another model, which would cost approximately ₹2,500.
Currently they are giving temporary resolution by brake bleeding process but it comes back in a few days only. Which is unacceptable
However, considering that multiple owners are reporting the same issue, this seems to be a potential widespread manufacturing or design-related problem rather than individual wear and tear. We believe Yamaha should take responsibility and provide a free replacement or permanent resolution under warranty, rather than charging customers for it.
I'm planning to write a formal email to Yamaha highlighting the issue. If their response is unsatisfactory or they fail to provide a proper resolution, we can consider filing a joint complaint with the Consumer Forum.
If you're an XSR 155 owner facing the same rear brake issue, let's collaborate!
Please DM me your email ID so I can include you in the email to Yamaha. The more affected owners who come together, the stronger our case will be.
Let's get Yamaha to acknowledge and resolve this issue!
r/Fixxit • u/supermannman • 1d ago
Unsolved need help analyzing tire wear on left side
https://postimg.cc/gallery/MM5YTR1
last 3 tires im getting a concave surface with heavy tread wear in the left 1/3 of the tire having me change the tire before the middle reaches its service interval.
im wondering of its the left shock dropping and thus the tire is scraping on the botton left side of the engine crankcase?
I just have no idea whats happening. it doesnt have its center stand and only use left side stand so maybe wear leaning on that side? it didnt do it prior to the last 3 tires Ive had and different tires were used. pirelli /pirelli /dunlop
sym maxsym 600cc
r/Fixxit • u/PossibleMobile3587 • 1d ago
Bought a "dead" 2008 KLR650 for $400. Water pump shaft threads are gone. Gen 2 balancer shaft removal question
r/Fixxit • u/PristinePiglet8419 • 2d ago
2006 Honda cbr 1000rr does it sound like the bottom end is going to give out?
Does anything sound wrong with the motor? I’m hearing a vibrating sound or a humming sound is the best way to explain it
r/Fixxit • u/Ecstatic-Angle4633 • 2d ago
Unsolved Jawa Perak (2022–23) keeps stalling when slowing down or braking. Any ideas?
Hey everyone!
I own a Jawa Perak (2022–23 model), and I’ve been facing a strange issue with the engine shutting off.
Here’s what happens:
The bike starts normally and idles fine in neutral.
After riding for about 1–2 minutes, whenever I slow down, apply the brakes, and pull the clutch, the engine silently shuts off just before the bike comes to a complete stop.
For example, if I’m riding at 50–60 km/h and see a red light, I start braking and downshifting. With the clutch pulled in and no throttle, the engine suddenly dies.
However, if I keep giving it a little throttle while holding the clutch, the engine doesn’t shut off.
This only happens when the engine is cold sometimes in hot too. But usually initially under 1-3 mins.
It has never stalled while riding at higher speeds.
Starting issue:
When the engine stalls, it usually takes around 2–3 attempts to restart while in gear (the starter cranks, but the engine doesn’t fire). However, it generally starts on the first attempt in neutral.
Another issue — possible clutch slipping:
My clutch plates are somewhat worn out. I’ve also noticed a loss of acceleration and torque compared to when the bike was new. If I suddenly give full throttle, the RPM shoots up, but the bike doesn’t accelerate accordingly. Gradual acceleration works fine.
What I’ve tried:
The check-engine light was previously on, so I took the bike to the authorised service centre. They replaced the ECU, and the warning light disappeared, but the stalling issue remained exactly the same.
My questions:
Could this be an issue with the throttle body, idle control, or fuel supply when the engine is cold?
Could worn clutch plates or incorrect clutch adjustment cause this?
Has anyone experienced something similar with their Jawa Perak, Jawa 42, or other Jawa motorcycles? If so, what fixed it?
I’d really appreciate any suggestions before I take it back to the service centre. I don’t want to keep replacing expensive parts without finding the actual problem.
Thanks in advance!
r/Fixxit • u/Rude_Addition_7279 • 2d ago
2016 Honda crf 230 issues
Hello, I am having issues with my dirtbike I’m not too sure how to describe it but I’ll try my best. I bought a new kill switch for my bike, before I switched it the starter worked perfectly fine, even when the kill switch was completely off it still ran, but ever since I connected the new kill switch the starter just does not work atall, not even a little and the battery is new. The part I don’t get is everytime I press the new kill switch the fuse cracks but I want to figure out how to get my bike working again, if anyone out that can help it would greatly be appreciated!
r/Fixxit • u/Longjumping-Bit-9402 • 3d ago
Unsolved 2009 Husqvarna WR 125 2-stroke lost power, died and won’t restart
While riding, my WR 125 gradually lost power and eventually shut off. The rear wheel didn’t lock up. Now it won’t start, and sometimes it makes a popping sound when I try to kick-start it. I might have left the choke on during the ride. Could that have fouled the spark plug? What should I check first?
r/Fixxit • u/nekonion • 3d ago
Exhaust discolouration, Should I be concerned?
reddit.comYamaha XSR700 2016
Just cautious, Video of how exhaust looks in the comments. Thanks!
r/Fixxit • u/52VwHoop • 3d ago
2004 Harley Davidson Electra Glide CVO SE 103 vibration.
reddit.comr/Fixxit • u/njr_6776 • 3d ago
Suzuki Access 125 (2014 BS3) starts but stalls immediately when accelerator is applied – Need diagnosis and mechanic recommendations in Chennai
reddit.comr/Fixxit • u/two-more-times- • 3d ago