This is on my '07 KLR650 with 17.8k on it. A previous owner installed a Doohicky with the torsion spring.
One day, driving down the interstate, I noticed some small lurches that didn't bog down the bike, and still got 45 mpg when I filled the bike up. Put my ammo can panniers on and the lurches became more apparent. WOT in second gear starting at about 20 mph and at 25 mph the bike got up to 4,500 rpm. The pattern of rpms above 3,500 I noticed the clutch slipping. Immediately thought clutch was shot at that point. I replaced the clutch with the Tusk competition clutch with the Barnett 501-44-05002 springs. It looked like an OEM clutch and springs that I replaced.
While the cover was off I checked the oil pickup screen and noticed a broken shim and some debris was caught. Called the guy that did the Doohicky and he said he replaced the tensioner before it broke, but didn't check the oil pickup screen when he worked on the bike.
Tested it out this morning for a ride and the clutch still slips. I made sure the clutch lever had slack in it; and it did, just not the 2-3mm of play the Clymers manual called for (1mm of play was measured). The adjustments were all maxed out as loose as possible by the clutch actuation lever and at the handle, so I cut off about ¼" of the hard tubing up by the clutch lever. Now I was able to readjust the free-play to 2-3mm.
Before I go out again, and given the info and photos I have provided, what would be the cause of the clutch slipping? I would rather not torch another clutch if possible to figure out the issue.