r/led • • 11h ago

Fluorescent to LED conversion

Thumbnail gallery
3 Upvotes

I picked up a 20-pack of GE LED15ET8G4840 4' LED bulbs a couple of years ago on sale at Lowes. Was planning on converting a bunch of fluorescent lights to LED. Turns out these wouldn't work with the generic fixtures I had, so I shelved it until later. Well later arrived and I started playing with some of the ballast-bypass solutions online. I've tried applying 120v hot to one and both terminals on either end, with neutral to the other, as well as power and neutral to either pin on one end or the other, but no reaction. Tried the same with a 12v 18a Ryobi battery, but nothing. I figured there should at least be some type of resistance across pins, but nothing with any combination tried. I'm seeing some comments that a Type A ballast is needed, but I'm not sure which one. Would appreciate any suggestions as to which process I need to use, and what part is needed if necessary.


r/led • • 2h ago

Is this an issue with the light itself? And if so, is it a lost cause?

Post image
2 Upvotes

This is a hardwired outdoor porch light that has seen some water infiltration. Half the diodes are dim but not off. The other half of the diodes are brighter and flicker between full strength and half strength.

I’m not totally sure how water is getting in here as it’s caulked all around and has a rubber gasket.

Any tips or should I just get a new one?


r/led • • 16h ago

Need new 12v power supply for cold weather - how do I replace?

1 Upvotes

I have kitchen LED strip lighting that is powered by a (cheap - see photo) 12V power supply. This has lasted about 5 years, but it's in the unheated garage attic, where it regularly sees very hot and very cold temperatures (Delaware). I've had a couple of other power supplies fail in this location, but this one's a little different - in those cases, I could access the wiring and just replace the whole thing.

I want to replace the power supply only - I need to use the existing low voltage wiring as it is inaccessible. So, a couple questions:

- First, very basic: Any problem to simply cut the low voltage cable from the defective supply and from a new supply and simply wire the new PS to the existing wiring? Can I use wire nuts or do I need to solder?

- Is there a recommendation for a higher quality power supply that can handle the temperature extremes? (I've attached a link to a possible product Power Supply because Reddit says I have to??)


r/led • • 23h ago

How an LED Lamp Works Light From Falling Electrons Animated

Thumbnail
youtube.com
1 Upvotes
How does an LED lamp make light without a hot wire? This animated cutaway shows what happens inside an LED chip: the P-N junction, electrons and holes, recombination, and the photons that become the light you see.

You will see:
• The parts of an LED lamp: dome, reflector cup, chip, bond wire, legs
• N-type and P-type semiconductor
• The depletion zone (the "wall") at the junction
• What happens when the battery is connected, and when it is reversed
• Why LEDs come in red, green and blue (the energy gap)
• How a blue chip and a yellow phosphor make white light
• LED vs filament bulb: where the energy goes

Chapters
0:00 A lamp with no hot wire
0:37 Inside the chip: N and P sides
1:25 The junction and its wall
1:52 Connect the battery
2:27 Recombination: an electron falls into a hole
3:10 Reverse the battery: no light
3:41 Why LEDs have different colors
4:05 White light: blue chip + phosphor
4:25 Dome and reflector cup
4:46 LED vs filament bulb
5:09 The whole story in 30 seconds

Hidden Mechanisms shows the inside of everyday objects as animated cutaways. Subscribe for the next one.

#LED #HowItWorks #Physics