r/watchmaking • u/Raziel_151 • 13h ago
Help Citizen 4-770111TA
I purchased a Citizen 4-770111TA, the crystal needed to be replaced. When removing the original crystal, the bezel holding the crystal popped off the case. The bezel had been glued by someone at some time.
I have replaced the crystal.
I think the bezel was original held in place by a gasket. I've tried gaskets from Cousins. The gaskets go on the bezel, but when I try to compression fit the bezel to the case it does not go in. I am using a crystal press that is pressing on the bezel.
Chat GPT highlighted Emmy Watches lists Citizen 393-4023 as the correct gasket. So I purchased this but when trying to fit it, it is small compared to the bezel. Chat GPT is telling me to place the gasket into warm tap water as this will help it to stretch - going to give this a go tomorrow. Are there any other suggestions?
Any help/advice much appreciated.
Thanks.
