r/watchmaking • • 23h ago

Question How to open this Monocoque?

Thumbnail gallery
15 Upvotes

My only guess is that it is through the dial, but diagrams would come in handy

Also, how to clean the absolute gunk it came "encased" into?


r/watchmaking • • 10h ago

Help Citizen 4-770111TA

1 Upvotes

I purchased a Citizen 4-770111TA, the crystal needed to be replaced. When removing the original crystal, the bezel holding the crystal popped off the case. The bezel had been glued by someone at some time.

I have replaced the crystal.

I think the bezel was original held in place by a gasket. I've tried gaskets from Cousins. The gaskets go on the bezel, but when I try to compression fit the bezel to the case it does not go in. I am using a crystal press that is pressing on the bezel.

Chat GPT highlighted Emmy Watches lists Citizen 393-4023 as the correct gasket. So I purchased this but when trying to fit it, it is small compared to the bezel. Chat GPT is telling me to place the gasket into warm tap water as this will help it to stretch - going to give this a go tomorrow. Are there any other suggestions?

Any help/advice much appreciated.

Thanks.


r/watchmaking • • 14h ago

Question Movement Reolacement

Thumbnail gallery
0 Upvotes

I need to replace the movement pictured. It has “Z205” stamped on it. Will try and find a local shop to replace it but wanted to see if it might be possible to do myself.
What I could find online says that is a common Chinese quartz movement.
Cousins UK is one of the places online that is supposed to sell them but their website is not working. There is one in AliExoress but there are some additional letters after the “Z205” and not sure if that makes a difference.
Is there another manufacturer like a Miyota that might have something to use instead?
Is this something fairly easy to do?
Thank you for any advice you may be able to share.