I’m trying to continue shooting a partially exposed roll of 120 film in a different medium-format camera, and I’d like to determine as accurately as possible where it is safe to resume.
Here is the exact situation:
I loaded an Ilford Delta 100 120 film roll into a Mamiya RB67 Pro-S (6×7).
I exposed frames 1 through 5.
After taking frame 5, I advanced the film one full frame further, reaching the frame 6 position, but did not take a photograph.
In complete darkness, I rewound the entire roll back onto its original spool.
I then loaded it into a Rolleicord Va (6×6), aligning the backing paper’s start arrow according to the camera’s instructions.
I advanced the film to frame 1 on the Rolleicord’s counter. No photographs have been taken with the Rolleicord yet.
My main question:
Can I safely start exposing from frame 7 on the Rolleicord, or should I skip frame 7 and begin with frame 8 to avoid overlapping the previously exposed frames?
I’m particularly interested in a calculation based on the actual film transport and frame geometry, rather than a general rule of thumb.
Ideally, the calculation should account for:
The difference between the 6×7 and 6×6 image dimensions.
The actual film advance per frame in each camera.
The initial distance between the backing paper’s start mark and the first exposure area in each camera.
Frame spacing and any mechanical tolerances or variations in film advance.
The fact that I advanced the film one additional frame after exposing frame 5 in the RB67 before rewinding it.
If you have done something similar
I’d especially appreciate responses from anyone who has transferred a partially exposed 120 roll between cameras with different formats or film-advance mechanisms.
If you have relevant experience, could you please provide more than just a rule of thumb such as “I usually skip two frames”?
It would be much more helpful if you could share one of the following:
The measurements or calculation you used to determine the safe starting frame.
Scans or photographs of the resulting negatives, showing the transition between the two cameras’ exposures.
The actual amount of overlap or blank space observed between the last exposure in the first camera and the first exposure in the second camera.
The camera models and frame numbers involved, so the result can be compared with my situation.
The specific goal is to establish whether frame 7 is genuinely safe to expose, or whether starting from frame 8 is necessary.
I’d rather avoid wasting a frame, but preventing overlap is the priority.
Thanks!