r/Detailing • • Oct 09 '24

I Have A Question Are ANY of you fuckers looking at the FAQ before posting?

27 Upvotes

r/Detailing • • Sep 20 '24

Products I recommend all the time

50 Upvotes

r/Detailing • • 11h ago

I Need Help! (Time Sensitive) Is my 8 year-old Alcantara steering wheel beyond saving?

Thumbnail
gallery
30 Upvotes

Hi everyone,

I’ve recently bought a 2018 Audi RS3 (8V) and I’m looking for advice on restoring the Alcantara steering wheel. I’ve only had the car for around a month.

What I’ve done so far:

  1. Cleaned using a microfibre cloth and warm water.
  2. Applied Sonax Alcantara and Upholstery Cleaner.
  3. Allowed it to dry completely.
  4. Brushed the material in one direction, then slightly upwards to loosen and lift the fibres.
  5. Repeated this process several times over the past two weeks.

The cleaning process has made a significant difference to how soft the material feels, but I’m struggling with the appearance and texture.

As shown in the photos, brushing the material flat in one direction gives it a much smoother appearance (second set of photos). However, running your hand in the opposite direction brings up the uneven, raised and almost frayed texture shown in the first set.

Brushing also seems to release small amounts of loose material. The improvement doesn’t last with normal use.
I haven’t used any sanding pads, abrasives or fabric shavers.

My questions:

  1. Is this beyond saving, or can the original Alcantara realistically be restored?
  2. Is there anything else worth trying?
  3. Can a pro detailer save this or should I expect a full retrim as my only viable option?

I’d ideally like to save the original material if possible.

Appreciate any advice!


r/Detailing • • 6m ago

I Have A Question How Much BH Touch-Less V2 Are You Putting in Your Foam Cannon?

2 Upvotes

Hey everyone,

I’m new to home detailing and trying to dial in my pre-wash setup and work out my actual Panel Impact Ratio (PIR).

I’m running an Active 2.3 with the Active Foam Cannon and 1.45 orifice. My first bucket test gave me a draw rate of around 31 litres/6.8 gallons (need to redo the test as it seems quite high compared to what I’ve seen online!).

For those running similar setups, how many ml of Touch-Less V2 are you putting in your 1L foam cannon bottle, and what PIR are you achieving?

All experiences welcome. Thanks!


r/Detailing • • 4h ago

I Need Help! (Time Sensitive) How to clean antifreeze/coolant spill in trunk and back seats

2 Upvotes

I recently discovered that a bottle of antifreeze spilled in my trunk it’s been sitting maybe a week?It seeped through the back seats. I put some cat litter back there to absorb the liquid but am not sure how to clean it from here. I’m considering taking it to a hand car wash and using their brushes and water hose to clean the mats and carpet if the back part is removable.

Please share some tips on how to do this! Thanks


r/Detailing • • 15h ago

Work Product- Look At What I Did 1966 Chrysler Newport clean up

Thumbnail
gallery
10 Upvotes

Nothing crazy. Just wanted to clean up this original single-stage paint without eating it all away. Good enough for a land yacht.


r/Detailing • • 3h ago

I Have A Question Vacuum cleaner & high flow pressure washer

1 Upvotes

Hi,

I'm looking for a pressure washer suitable for washing at least 4 cars per day, specifically for professional car detailing.

I'm finding it difficult to choose between all the different brands and models. Second-hand equipment is also fine, but I'd like to know which brands are reliable and suitable for intensive daily use.

Would I need any additional spray nozzles or accessories?

I'm also looking for a suitable vacuum cleaner for professional car detailing.

My budget for both machines combined is around €500, but feel free to recommend more expensive options as well, as I'll also be checking the second-hand market. Im buying in the Netherlands! So please somethinf available here, is bigboi good ?

Thanks in advance!


r/Detailing • • 3h ago

I Have A Question Ozone generator smell (need help, please)

1 Upvotes

I just got my car (suv) detailed today and they used an ozone treatment as well. They said they ran it for 3 hours and left it to air out for one. My car smells like an awful chemical soup. Like Chlorine and bleach. I aired my car out again when I got home but every time I lock the car up and open it again, the smell is just as strong. Any recommendations on how I can eliminate this terrible , toxic odor? I am also researching and now discovering after the fact that three hours is a LONG time to run an ozone generator but I trusted the detailer when I dropped off my car. To say the least, I’m worried. Do I need to replace cabin air filter, etc? Has anyone dealt with this before. Any help is very, very appreciated!


r/Detailing • • 8h ago

I Have A Question Which pads should I get for 3D one?

2 Upvotes

I have marrying and swirls in my black paint. I want to remove them. Basic 1 step.

Which pad or pads should I get ?


r/Detailing • • 11h ago

I Have A Question How clean a spot on leather seat

Post image
2 Upvotes

I recently bought a 2023 Audi Q5. There’s a spot on the passenger seat. The seat overall is matte and textured. The area with the spot is mostly smooth. I’m not sure if it’s even “cleanable.” Any ideas?


r/Detailing • • 12h ago

Work Product- Look At What I Did Update to my post from a few days ago. Before and After.

Thumbnail
gallery
2 Upvotes

Turned out that someone tried to DIY ceramic coat and it went bad. Used Jax Wax Scratch Remover by hand for about four hours until my boss said it would take too long to do the rest of the car and gave it to a specialist with a buffer.


r/Detailing • • 10h ago

I Have A Question Unknown age of my ceramic sealant

1 Upvotes

I bought a 2014 jeep wrangler last year and the paint still looks amazing! There's a sticker on my windshield from a detail shop that says do not wax ceramic sealant. When I called business on the sticker I found out they're out of business. The guy I bought my jeep from owned it for 6 yrs and the sticker was on the windshield when he bought it. He said all he's done was just running it through the carwash and kept it in the garage. What do I need to do to keep it protected and looking good? I'm a plumber and auto detailing is out of my wheel house so any advice will be greatly appreciated..


r/Detailing • • 7h ago

I Have A Question Would you guys buy this Meguiar’s deep crystal wash even with this weird blue stuff at bottom?

Post image
0 Upvotes

r/Detailing • • 11h ago

I Have A Question What IS this stuff on my black paint? It comes off if I scratch it with my nail.

Thumbnail
gallery
1 Upvotes

My car is a 2009 Nissan so I’m sure this is normal for its age and its color, but I can’t figure out exactly what it is.

It’s only on the back of my trunk & the top of my car. It shows up in somewhat circular spots.

In the first two pictures you can see where I took my nail & scratched some of the white stuff off — so I don’t think it’s my paint/clear coat — I think it’s sitting on top of it. I didn’t try to scrape off anymore, I just did a small spot to test it.

Initially I thought it was just serious hard water stains/calcium build up, so I took a hot microfiber towel, let it sit on one of the spots to “soften” it up & scrubbed it using diluted soap & a soft sponge. It did little to nothing.

Being a female I’m pretty handy, know how to use power tools, can run a miter saw, stuff like that (lol) & dated a guy whose parents owned a detail shop for 5 years so I’m pretty familiar with a lot of things.

But I can’t figure this out. Any suggestions?


r/Detailing • • 1d ago

I Have A Question Dried coffee under seat, clean now or in summer

2 Upvotes

So my wife had a travel cup of coffee in my car. I’ve just found it under the seat, must’ve rolled under. But it’s leaked dregs of coffee.

I’ve had a musty smell in the car for a while and I’m guessing it’s this.

Anyway

It’s currently below freezing in the UK. Do I leave the dried coffee until Summer or is there a DIY way to get it out and dry it without making my car damp.

I have loads of products and a cheap wet/dry shop vacuum.


r/Detailing • • 1d ago

I Have A Question Is there anything I can do? Car is sentimental. Looks like clear coat failure.

Thumbnail
gallery
5 Upvotes

2016 Audi Q5. This was my dad’s car. I bought it from my evil narcissist stepmother when he passed away from bile duct cancer about 1.5 years ago. I just noticed these two spots after a thorough wash and decon to prepare for a round of polish and sealant before winter.

If it isn’t something I can tackle easily, I’m willing to take it to a shop. I’ve invested a lot in this car and plan to keep it for at least another 10 years. I thought German cars had tough clear coats. If it isn’t something that can be remedied easily or adorably, is there a way to prevent it from getting worse while I save up the cash?

Thank you.


r/Detailing • • 1d ago

I Have A Question Does anyone have success stories in there detailing Bussiness’s

0 Upvotes

Does anyone have success stories in their detailing Bussiness’s in smaller city’s with population with like 10-20K?
If so what’s the numbers look like?
Yearly revenue
Customers a day/week
Is it worth it or do you wish you were located in a bigger city with 100k+ population?


r/Detailing • • 1d ago

I Have A Question Accidentally sprayed rust remover on beige dashboard. Can this be cleaned off?

Thumbnail
gallery
12 Upvotes

Asking fro a friend, she accidentally grabbed the wrong bottle while cleaning the inside of windshield and sprayed GRASS Rust Remover Zinc instead of glass cleaner. It dripped onto the beige dashboard and surrounding trim and left these chalky-looking spots post-factuum

The car ibtw s a 2011 Ford Escape limited. The affected pieces have different textures, and I am not sure whether they are all the same material or whether some have a painted coating. I have attached close-ups and a picture of the product.

I am trying to figure out whether this is dried residue sitting on the surface or actual damage to the colour/finish. Is there a sensible way to tell the difference?

What would you try first on this kind of textured interior trim, and how would you apply it? Specific products would help. I would like to preserve the original texture and avoid making the spots worse. If cleaning cannot fix it, what would be the best repair other than replacements as that's not an option currently?


r/Detailing • • 1d ago

I Have A Question Bug and Tar remover plastic and rubber safety

2 Upvotes

Hey everyone, I've been doing my annual tar spot removal, and i've been using "Turtle Wax Bug and Tar Remover". It says its safe on plastic, glass, paint, metal, etc... It also says after application, just buff the panel to a shine (or similar).
.
The gloves i've been using it with (elbow grease green long sleeved) disintegrated at the finger tips.
.
So for people who have been using products like this for long; how safe is it actually on plastic, rubber etc... like the rubber under the door handles, around the parking sensors, window seals, etc...
.
How safe is it to leave on paint? Usually i wash the panel with shampoo after application, but this time i haven't had the time for that. In the past, i have had paint get removed from the non-clear coated front grill plastic before.


r/Detailing • • 1d ago

I Have A Question Griots or Viking care crinkle glass towels

2 Upvotes

Which are better from the looks of it both Viking care and griots crinkle glass towels look the same but are different price.anybody got idea or experience with which is better


r/Detailing • • 1d ago

I Need Help! (Time Sensitive) Meguiars Scratch X for what seems to be paint transfer?

Thumbnail
gallery
1 Upvotes

The second photos are before, the first photo is after I rubbed it with some isopropyl. Will Scratch X get the rest off? Will it damage it further? Are the scratches too deep?


r/Detailing • • 1d ago

I Have A Question Any good starter kits for newbie?

3 Upvotes

I just got a new car and know almost nothing about car care and detailing. Just looking for some suggestions on a simple and quick way to keep the outside looking clean. Where is a good place to start and what products to start with.

Not looking for anything crazy yet. Just a simple exterior wash is mostly what I need.

I saw Jax Wax has a starter kit for black friday around $100. Not sure if that is worth it or not and if that even comes with everything I need to get started. Any suggestions would be appreciated!


r/Detailing • • 2d ago

Work Product- Look At What I Did What do we think? This was my first real two step attempt.

Thumbnail
gallery
18 Upvotes

I’m working at a dealership as a detailer and was given this car and the freedom to do a two-step correction. I had very minimal equipment, terrible lighting, and no real polishing pad.. So how’d I do?


r/Detailing • • 1d ago

I Have A Question Anyone know how to remove these stains from plastic bit in a car

Post image
1 Upvotes

I don’t know if there oil stains or what but ive had them for a while.