r/electrical • • 3h ago

What Gauge wire is coming from 30Amp Breakers

Post image
34 Upvotes

Long story short my water heater should have 3 40 amp breakers but someone put 3 30s. Tried to follow the sheathing to see what gauge but no luck. If it’s 8 I can swap without having to run new wires which would be nice. Thanks m.


r/electrical • • 20h ago

Well it happened (wago fail)

Thumbnail
gallery
415 Upvotes

Week old setup. Yea I made sure it's tight and inserted completely. No I don't know why. It's genuine as far as it looks. Yea I will continue using them.


r/electrical • • 4h ago

How to extract sheared off screw in outside electrical box that is encased in limestone/mortar

Post image
15 Upvotes

I have tried making a pilot hole and then using the ryobi extractor but it wont bite enough for me to use pliers to remove it. I am afraid of hammering the extractor into the screw any more for fear of damaging the mortar/electrical box and escalating it into a more expensive problem!


r/electrical • • 38m ago

Grounding for 100amp sub panel in shipping container

Thumbnail
gallery
3 Upvotes

Am I doing this right?

8’ stainless ground rods 8’ apart. #6 THHN wire. Will run into 100amp sub panel fed from pedestal. I used 1 continuous and stripped at clamps.


r/electrical • • 1h ago

Lights flickering and then burn out

Post image
2 Upvotes

Lights in different rooms are flickering then burning out. I replaced them with new light bulbs, and the same thing happened. Is there a loose neutral somewhere possibly or something else? I recently got a new dishwasher installed. I will check the connections on that next.


r/electrical • • 2h ago

Is my light fixture scorching my ceiling?

Post image
2 Upvotes

I'm not usually home at this time of day, when there's natural light to see things very clearly, but just noticed brown "patches" on my ceiling above this light fixture... They're not shadows, I got up on a chair and moved the lights around to make sure.

Could the bulbs be getting hot enough to burn the paint on my ceiling? (Thankfully it's a concrete ceiling).

The bulbs are 40W halogen and the light fixture has been here since we moved in, so at least 10 years old.

I suppose I could change to LEDs and it would stop, right? Or do I maybe have a more serious issue happening here?

thanks!


r/electrical • • 48m ago

Chicago ceiling light wiring

Post image
1 Upvotes

Hello everyone. I have a ceiling light fixture that needs to be swapped out. When opening up the ceiling junction, there were a lot more wires than I was expecting. I'm in Chicago, so I know Chicago has specific wiring requirements that are different than other parts of the US. The photo shows 3 blue wires, 2 white wires, and 1 red wire. The light fixture (without fan) only has 3 wires. Can someone help me with knowing what's what? The red wire wasn't connected to anything. And I just undid the old light fixture to see what was inside. The fixture came crashing down, and I was unable to take a photo of the previous wiring before it came crashing down.


r/electrical • • 2h ago

Breaker in new house

Post image
1 Upvotes

r/electrical • • 3h ago

It looks like a boil has appeared, is it due to overheating?

Thumbnail gallery
1 Upvotes

r/electrical • • 4h ago

Horizontal 120v outlet?

Post image
0 Upvotes

I’m looking for a WR horizontal 120 outlet, the only thing I can find is this Eaton 1208W surge protection outlet. I’m replacing a horizontal outdoor outlet and want the cords coming down out of the weatherproof box instead of out the side.

Any ideas?


r/electrical • • 23h ago

0-140v transformer?

Post image
18 Upvotes

Found while cleaning out my late grandpa's garage. Just trying to figure out what this is used for


r/electrical • • 10h ago

Quick question

Post image
1 Upvotes

Hey guys.

I have a three gang switch at my entryway wired exactly like this. The left switch, has always been hooked up but it never actually turned anything on which has been weird but I lived with it. The middle switch is for the entry ceiling light and the right switch is for the exterior soffit lights.

The other day, my wife bumped into the wall next to the switches and all the lights went out. I checked the breaker and nothing was tripped. I ended up switching out the old metal three gang box for an old work blue box and installed three new Lutron switches. However, the lights still aren’t working. I flipped every switch on the breaker panel just in case and the lights still aren’t working. Has anyone seen this before and have any solutions? Just checking before I start cutting into walls to trace the romex for shorts or other issues.


r/electrical • • 11h ago

Mysterious outage

Thumbnail
gallery
0 Upvotes

THIS PROBLEM IS NOT SOLVED, I don’t know why that button is there.
Lights are on 2 way dimmer switches. All failed to turn on when we got home. No other lights in the house were affected. I checked the circuit breakers, the GFI switches (even the ones that weren’t in the vicinity). When the house was built in 1990 there were just 2 can lights. 16 years ago I installed new cabinets and counter tops. Shortly after hired electricians to add the additional can lights. They drilled holes in the ceiling then fished romex through the holes. One end of two pieces in each hole. Wired fixtures and punched them in.

The question is , if they are wired that way will one bulb going out make them all go out?

Any help would be greatly appreciated


r/electrical • • 11h ago

what’s going on with my electricity/power?

0 Upvotes

yesterday morning my mom was blow drying her hair and also had a small plug in heater on in the same room. after she turned off the blowdrier, we lost power. we assumed it was the same as before, this happened in the past, but it never happened after turning off the blow dryer, only when both were on.

we soon realized it was just our bedrooms that were affected, no where else in the house, not even the bathroom and closet connected to my room. we called our neighbor who helped us fix it in the past, but to no avail, it didn’t work this time, which is when he told us to call the property manager. we called him this morning, he sent some electricians, and everything went back to normal. however; after my mom went to bed, sometime between the 2 ish hour gap between her going to bed and me getting ready for bed, i realized we had no functioning lights in the house except the living room. just the living room

i fiddled with the fuse box, and i ended getting the power back on in every room except ours, same dilemma as yesterday. i accidentally switched on a useless light switch in my room, which made a loud pop sound, followed by a burning smell? now none of the power works except the living room once again.

the issue is, nothing happened between my mom going to bed and me getting ready. the only two outlets that were used was the one with the heater on in her room, and the living room with the light and my phone charger. just wondering if anyone could have a possible solution.


r/electrical • • 15h ago

Grounding light fixture?

Thumbnail
gallery
2 Upvotes

I have a pretty old chandelier attached to a dimmer switch. I wanted to swap it out for a more modern fixture but saw the ground wire is just wrapped around a metal bar that screws into the box (see photos). Is this acceptable or do I need to call an electrician to fix the grounding?


r/electrical • • 16h ago

Smart Thermostat

Post image
2 Upvotes

This might be better suited for an HVAC thread or smart home but I thought I’d try electrical first. I want to install a smart thermostat and I was checking the needed specs for the device. Is this top one W or O/B because on the manufacturer site it wanted to know if I had one or the other of that type of wire.


r/electrical • • 16h ago

Thoughts on water damage

Thumbnail
gallery
2 Upvotes

Hello - realized recently my water panel took on some water. The breakers have a little bit of surface rust but screws and connections look alright. Panel is relatively new. Want to know if you see anything major here that I should be concerned about in the short term


r/electrical • • 1d ago

Door Bell - no electric?

Post image
22 Upvotes

I’ve lived in my house for five years and don’t recall ever hearing the doorbell ring, I assumed it is because shortly after I moved in, I installed a battery powered smart doorbell. Just bought a wired smart doorbell on a Black Friday deal and went to install it today. Turns out the doorbell is not even getting power (no indication from my voltage tester). Breakers look fine. What would you do next?

Edit: thanks for those of you that had actual constructive suggestions. I did not find the transformer, so it is likely in the attic. Not worth it to pay electrician to come and replace it, so I would likely go back to a battery powered doorbell

Edit 2: I removed the chime cover and identified the wire that was going to the trans screw. I was able to find that wire in my basement, and lo and behold, there was the transformer attached to the left side of my electrical box. If it was a snake, it would’ve bit me as they say. Found that one of the wires had gotten loose, so when I reattached that my doorbell is now operational. Onward to connect the video doorbell. Thanks to all who were not smart asses in their responses.


r/electrical • • 4h ago

Can anyone tell me what this is?

Post image
0 Upvotes

It’s continually ticking and I’m not sure what it’s used for?


r/electrical • • 14h ago

AFCI tripping while gaming

1 Upvotes

Hey all,
I have a 2018 house with a Schneider home line panel installed.
Since playing GTA 6 for the last few days now my 15amp AFCI that my PS5 is plugged into has tripped twice now.
I have replaced the breaker after the first time it did it on Thursday but it did it again tonight.
Happens after around 2-3 hours of playing. Happens completely out the blue.
It happened a couple of years ago as well with God of War Ragnarok, but hasn’t happened since, until Thursday.
I have a 10 year old dimmable lamp plugged into the circuit as well.
I don’t want to replace my PS5 until I’ve made sure everything else is okay.
Any suggestions would be appreciated.
Thanks!

EDIT: Could be worth mentioning that my PS5 is an OG day 1 fat PS5 from 2020. I’m not a hardcore gamer by any means either. Just casual.


r/electrical • • 14h ago

Any info on how to troubleshoot open grounds?

Thumbnail
gallery
0 Upvotes

I replaced the outdoor lights a year ago with ones that had an outlet on them. I am almost positive I made sure it was grounded because I plugged my pool pump into it. (I know, but ..). The light deteriorated in the Texas sun. Today when I replaced the light with a 2 gang for 2 outlets, I get open ground. It's a 20amp circuit, and 12/2 wire and I wired it up like this image as I've done a few times before- its the end of the line. Part of todays plan was to also change one of the outlets before these to a CGFI for more protection. I because I'm going to still plug in the pump and now add some lights. Turns out, the outlets before this one aren't grounded either Why would 14/2 not be grounded? Getting in my attice to this line is pretty much a no go for me. Any troubleshooting or info or videos? I've wired a lot of things in my life, but I'm stumped. Thx


r/electrical • • 15h ago

Fluorescent to LED conversion

Thumbnail gallery
1 Upvotes

I picked up a 20-pack of GE LED15ET8G4840 4' LED bulbs a couple of years ago on sale at Lowes. Was planning on converting a bunch of fluorescent lights to LED. Turns out these wouldn't work with the generic fixtures I had, so I shelved it until later. Well later arrived and I started playing with some of the ballast-bypass solutions online. I've tried applying 120v hot to one and both terminals on either end, with neutral to the other, as well as power and neutral to either pin on one end or the other, but no reaction. Tried the same with a 12v 18a Ryobi battery, but nothing. I figured there should at least be some type of resistance across pins, but nothing with any combination tried. I'm seeing some comments that a Type A ballast is needed, but I'm not sure which one. Would appreciate any suggestions as to which process I need to use, and what part is needed if necessary.


r/electrical • • 22h ago

Christmas Lights

Thumbnail
gallery
3 Upvotes

Is it safe to install Christmas lights here? Me and my wife just recently bought our first house and we’re (I’m) going to line our house with lights, but I just want to make sure about this area before hopping up on the roof. Thanks!