r/EngineBuilding • • 14h ago

5.3L v8 2010 1500 Sierra crew cab GM 4th gen with the damn AFM. Not yet deleted. How do I mod this

1 Upvotes

I just inherited a free truck. It is in a very well maintained condition. Run very smooth. It does still use the AFM. I noticed while driving Highway it toggle from INST ECON V8/V4
After I delete this bullshit, where do I go. I don’t know much outside of blinker fluids.


r/EngineBuilding • • 15h ago

C4 transmission (bar?)

Post image
50 Upvotes

Ok, I know it’s not an engine, but it’s in the family? Lol.

I know this bar circled in red does not go there and I assume the previous owner put it on there to hold the TC while being stored…. My question is, is this a bracket or part to a classic Mustang? Does anyone know what it really is?


r/EngineBuilding • • 23h ago

Valve stem tip broke off – Chevy 355 SBC

Thumbnail
gallery
26 Upvotes

About 3 mm of a valve stem tip broke off on my rebuilt 355 SBC.
L31 Vortec heads and original valves, Summit SUM-K00042 cam kit, SUM-141700PL roller-tip rockers, and stock pushrods.
The engine completed its 20-minute cam break-in. Rocker contact patterns look centered.
Any ideas what could cause this? Wrong geometry, valve springs, or a defective valve?


r/EngineBuilding • • 10h ago

Rotating assembly is balanced, starting reassembly with fully forged bottom end.

Post image
66 Upvotes

r/EngineBuilding • • 11h ago

Help with cam shaft

3 Upvotes

So i am getting my twin turbo big block chevy engine for my jet boat rebuilt because I had a cracked piston and cracked heads. I am using a mechanic that was recommended to me by a ton of people but im having a small issue with the cam shaft he chose for the build.

The engine is a 496 bbc with a gale banks twin turbo setup on it. Its got 360cc flotek aluminum heads, SRP flat top forged pistons, H beam rods, stainless steel valves, and more.

The engine builder chose a clay smith custom grinded hydraulic roller cam shaft for it and here are the specs:

Intake duration: 316 degrees(advertised)/ 259 degrees(at .050”)

Exhaust duration: 317 degrees(advertised)/ 263 degrees(at .050”)

Lobe separation angle: 110 degrees

Centerline timing events: 107 degrees intake/ 113 degrees exhaust

Intake valve events (.050”): opens at 22.5 degrees/ closes at 56.5 degrees

Will this camshaft work for my twin turbo setup? Is there going to be too much overlap? This gale banks turbo setup doesnt produce a ton of boost but it should be around 15 pounds. Im hoping for around 800-1000 horsepower on the dyno once its built.

Thanks