r/EngineBuilding • u/feelin_raudi • 10h ago
r/EngineBuilding • u/Swellmidwest • 15h ago
C4 transmission (bar?)
Ok, I know it’s not an engine, but it’s in the family? Lol.
I know this bar circled in red does not go there and I assume the previous owner put it on there to hold the TC while being stored…. My question is, is this a bracket or part to a classic Mustang? Does anyone know what it really is?
r/EngineBuilding • u/lynyrdskynnyrd • 23h ago
Valve stem tip broke off – Chevy 355 SBC
About 3 mm of a valve stem tip broke off on my rebuilt 355 SBC.
L31 Vortec heads and original valves, Summit SUM-K00042 cam kit, SUM-141700PL roller-tip rockers, and stock pushrods.
The engine completed its 20-minute cam break-in. Rocker contact patterns look centered.
Any ideas what could cause this? Wrong geometry, valve springs, or a defective valve?
r/EngineBuilding • u/SndMetothegulag • 20h ago
Ford Ford FE (Probably 390) 2100v carb setup help
Got a funky 1967 thunderbird with an unknown FE engine with a basically junk 2v carb and a 1968 truck intake. Guy who sold it claimed 429 (obviously isn’t) but honestly thought it was a 429 for some reason (Good dude, still helping me out with it ). Cars frame and most of the body is rot free and it’s a perfect project. I’m having issues figuring out the hookups on the carb due to how the guy before me handled everything (cut first, label never). I have a manual but it has been very little help as it seems to assume things would be setup in a stock position, not being put back together from a pile of parts in the trunk of the car. The photos show my attempt at the throttle linkage, and have parts/tubing circled that I am confused on where it goes or what’s missing from it. The final photo shows the top plate ?linkage? that for some reason does not open the top plate when opening the throttle body up. I am wondering if anyone has helpful diagrams or information on any of these components. Also information on where the vacuum lines on these hook up.
r/EngineBuilding • u/whiteboy2488 • 11h ago
Help with cam shaft
So i am getting my twin turbo big block chevy engine for my jet boat rebuilt because I had a cracked piston and cracked heads. I am using a mechanic that was recommended to me by a ton of people but im having a small issue with the cam shaft he chose for the build.
The engine is a 496 bbc with a gale banks twin turbo setup on it. Its got 360cc flotek aluminum heads, SRP flat top forged pistons, H beam rods, stainless steel valves, and more.
The engine builder chose a clay smith custom grinded hydraulic roller cam shaft for it and here are the specs:
Intake duration: 316 degrees(advertised)/ 259 degrees(at .050”)
Exhaust duration: 317 degrees(advertised)/ 263 degrees(at .050”)
Lobe separation angle: 110 degrees
Centerline timing events: 107 degrees intake/ 113 degrees exhaust
Intake valve events (.050”): opens at 22.5 degrees/ closes at 56.5 degrees
Will this camshaft work for my twin turbo setup? Is there going to be too much overlap? This gale banks turbo setup doesnt produce a ton of boost but it should be around 15 pounds. Im hoping for around 800-1000 horsepower on the dyno once its built.
Thanks