Picked up this 2016 for cheap with hail damage. 160k, no record of the tb being done and a lot of other maint that hadent been done.
Started buying parts from the get go to do everything.
Tb/wp, gates kit
Serpentine belt+tensioner, gates kit
180* thermostat, gates kit
Intake manifold gasket, felpro
Throttle gasket, felpro
Valve cover gasket, felpro
Noise maker delete, whoosh
Trans side shift bushings, whoosh
Trans oil, motul dctf
Plugs, ngk 1 step colder
Watched a few videos and glanced over the service manual, but havent worked on the 1.6 before.
The 10pc dp tool kit includes everything you need, dont buy the 18pc
You need 2x m10 x1.5 flange nuts to hold the flywheel locking plate in place.
7mm( hose clamps)
8mm(most)
10mm(intake manifold/starter)
13mm(most larger hardware)
15mm(alt mounting)
17mm(fuel line)
18mm(crank bolt)
19mm(motor mount)
E torx 6(alt stud)
I took apart way more than was needed for just the tb/wp because of the other work I was doing.
I took out the battery box to get to the shifter bushings as well.
Idk why this myth keeps getting repeated, but you do not need to pull the axle to get to the tdc pin
Remove 2x 13mm nuts on the strap, 2x 13mm bolts on the mount come out. Wrench on the 3rd slotted one and the entire thing slides out of the way
Use the starter bolts+m10 nuts to hold the locking plate. Put the bolts in backwards from normal to avoid dropping the nuts in the belhousing.
Ac compressor needs to be loosened to get the thermostat housing off. Terrible design.
Intake manifold is easy enough to remove, not sure I would fight with the starter with it in place, especially after the alt is removed.
Alt mounting stud needs to come out/in with the alt. Theres not enough room to slide it on.
All of the electrical connections are fairly self explanatory and only fit one way.
Its a good opportunity to walnut blast the valves as everything is apart. Hobofreight blaster+fine media is $65. I extended the nozzle with some poly tubing.
Valvcover was leaking for quite awhile. Went through about 5 cans of brakeclean
Belt had 1 outside crack and most of the teeth on the inside. Probably good for 200k, but not worth the risk.
My trans took 2 full qts with nothing dripping out. Front end was lifted however. Shifts way nicer with fresh fluid and solid bushings.