I have been working on my first proper PCB for about six months and I'm very close to the point where I'm going to have some engineering samples manufactured and assembled.
Background: there is none. This is a hobby project which I sort of span off something I did for work a while ago and it snowballed into consuming a significant amount of time, with immense scope creep and it's gone from something that was just going to be for learning/development and a couple of boards which would be mainly for personal use, to something that I am seriously considering turning into a commercial product, or at least it'll be the backbone of a potential commercial service.
The board is an asset tracker. I know these are widely available already but none meet the specific requirements I had in mind originally...and mine is extremely flexible now.
Four layers, 96x48mm, and has RF (LTE/LoRa and GNSS). Power is via battery, USB, external DC input (all can be connected simultaneously, with DC prioritised over USB; it will charge the battery too). The brains is an RP2350A.
Disclaimer: I am not an electronics expert and I have used AI to help with the schematics and part selection. I did a rough layout myself, and I am paying JLC to do the routing. There has been a bit of back and forth as me (and AI) have spotted small issues which the JLC engineer has happily rectified. I have tried my best to meticulously follow the hardware design guide for every chip on the board, some of which are very stringent (anyone who has put an RP2350A on a board will know about that inductor). I'm obviously not an expert but it looks to me like JLC has done a pretty good job with the first pass of the routing, and the impedance control seems to follow best practice. The PCB does not have antennas; there are U.FL connectors for both modules and they are on opposite edges of the long sides of the board and the areas around the RF traces are densely stitched with vias.
I've done some PCBA quotes with JLC and it looks like I can get the first 6 boards manufactured for just under US$100 each all in, which is great because it's below my target price. There are three hardware versions of the board which are virtually identical other than using different modems (two LTE and one LoRaWAN) and I'm going to panelize all three and then get two panels assembled as the engineering samples as this seems the most economical way to do it. I obviously really want the first versions to just work, although I am anticipating there will be at least one issue. I've become so obsessed with trying to ensure perfection with the v1 samples that I keep going through the schematics triple-checking them, re-reading all of the datasheets to make sure I've done everything right, and I'm sometimes even having nightmares about it. Each time there's something minor I find that I want to change although most of these would probably not cause the boards to be a complete failure.
So after all that my question really is: what else is there that can go wrong, even if I get everything right? Can JLC mess up the assembly and send me dead boards? Can parts be oriented wrong because datasheets have got incorrect diagrams?
Really appreciate any input, and as I said I'll post up some schematics and the layout for review once I get the latest version from JLC.