Good morning. Just looking for more information or confirmation or validation.
Long story: my mk6 gti got totaled in October. I am leaving for Germany (military) in January. I went to Missouri to pick up my s2000 that’s been in climate controlled storage for 7 years. All my stuff is gone due to the move, so I am using a friends garage.
To recommission it I changed the following: oil, oil filter, diff fluid, trans fluid, fuel pump, fuel strainer, fuel pressure regulator, drained the fuel tank (looked pristine), new injectors, coil packs, spark plugs and did valve clearances.
It eventually started, went to 2000 rpm for about 2 seconds, then went to 500 rpm and had rough idling. Anytime you gave it gas, it’s die. So I relooked at everything I had done. Kept having the same problem. Eventually did a compression test, 160 on cylinder 1,2,3, cylinder 4 is 120. Put some oil down the spark plugs tube, did it again. 130.
So then I did a leak down test. 40 psi. Hooked up to cylinder 4 at TDC, and air escaped from cylinder 3’s spark plugs tube. No where else. Coolant expansion tank was silent, throttle body silent, exhaust silent.
So then I did a leak down test on cylinder 3. Put it at TDC, pressurized, and no leaks at all. I would have figured that the air would have gone to 4 as well if the headgasket was bad betwixt the two cylinders… but I have no idea.
Anyways, my question is, if anyone has any ideas or advice or has dealt with something similar, please give me input. Does the 10 psi increase in cylinder 4 while pressurizing imply bad piston rings for 4?
Currently going to pull the head later today, and inspect to see what it looks like.
Thanks for your time! Pics attached in case anyone wants to take a gander.