Do you guys run this manifold restrictor gasket on your cars? It's the one that goes between the exhaust and the heat riser tube on the drivers side.
I recently rebuilt the motor on my ghia and I re-used the single port intake manifold that came with the car. The heat riser tubes were completely clogged, so I cleared it out as best as I could with an old clutch cable attached to a drill. I'm sure the passage is still pretty restricted compared to when it was new, but it seemed good enough. After running the engine, I noticed what seemed like excessive condensation/frost on the intake manifold under the carb.
I had to pull the engine back out to deal with a pushrod tube oil leak, and I'm wondering if, while I have the engine out, I should replace the restrictor gasket with the larger opening to help my condensation issue. I've noticed a lot of the gaskets sets you can buy don't even come with a restrictor gasket.