Hello! Never posted here and I'm very new to firearms in general so apologies if I am not saying stuff right.
Photo 1 is what its supposed to look like (manually pushing it into correct position) and photo 2 is where it is, and photo 3 is a big red circle around the issue.
Due to this misalignment the left shell latch would not disengage and therefore cartridges are not being let out from the tube.
How this works is the rail on the pump has this little ramp the pictured metal piece is supposed to get pushed up onto sliding onto the left side of the rail (on the outside) allowing the next cartridge to cycle.
However this metal piece is bent/positioned >1mm downwards causing it to ever so slightly not be flush on the metal so the ramp hits the middle instead of scooping it up.
I came up with 3 options and I want to run it over with more people than myself.
1 File the shell latch into a ramp so I don't need to mess with anything and they will just ramp onto each other. I could also do some gentle de-burring while I'm at it (definitely plenty of factory burs lol). But the big downside is I'm taking off material and I don't want to mess it up further.
2 Put a very small something (thin layer of solder?) under the shell latch in a place where there are no moving parts so it sits high enough to get caught by the rail ramp (there are plenty of spots, it widens a lot after this metal piece and the tolerances on this gun are low) but I don't know what I would put on it that would stay put permanently. I can also wedge something under it which would work as well but again isn't very permanent.
3 Get it replaced/repaired professionally. Frankly I don't want to do this for financial reasons and also I like fixing my own stuff.