r/ElectricalHelp • • 23h ago

Help with wiring

Post image
2 Upvotes

Hello all. I have a light fixture in the basement that seems to have quite a few wires spliced into it, this was not how it was originally set up. I think somebody went in here. I’m not quite sure over the past couple years and decided to jerry rig a couple of circuits together. This one looks like it connects to the living room lights as well as a bedroom light upstairs, which should not be on the same circuit, but we’re here, so I’m trying to find advice as to how to connect this properly when screwed in the light bulb flickers as well as the other lights that are along the circuit and I’m not quite sure what was wired incorrectly


r/ElectricalHelp • • 17h ago

Lights flicker when washer is running

1 Upvotes

Hello!

As the title says, when the washer is running, my kitchen lights flicker.

- The flickering happens only during the agitation part of the cycle.

- You can hear/see that the flickering is in sync with the agitator moving back and forth

- The lights and washer are on different circuits, but they are on the same side of the breaker panel

- The laundry room is adjacent to the kitchen - the cables likely take the same path to the breaker panel (I haven't checked)

- We haven't noticed it with any other lights

- The light fixture probably uses LED bulbs (I'm not 100% sure if I've switched that one to LED yet, but I'm pretty sure I did. I can check, if it matters)

Any advice? It drives my wife nuts!

Thanks!


r/ElectricalHelp • • 21h ago

Voltage Regulator?

1 Upvotes

Having land issues hooking up my mother's trailer home and been waiting 10 yrs for a power line extension so I ran a 12 awg extension cable from my house (300 ft) to run her breaker panel. But the voltage drops down to about 90 volts when loads like the refrigerator kicks, which limits what she can turn on until the fridge kicks off. So I'm looking install a digital voltage regulator for her (like the Larson Electric 10kva single phase VR about $7K). Was wondering what the expert opinions are on this. I know that upsizing the cable to #2 or so might be acceptable but I'm not sure if this will bring the voltage drop up to an acceptable level. TIA all.


r/ElectricalHelp • • 15h ago

GFCI - High Temperature

0 Upvotes

I pointed my thermal gun at the GFCI in the washroom. It read about 36+ degrees Celsius(96 Fahrenheit). This seems high, there is nothing plugged in.

We replaced it with a new outlet, same thing, it runs hot.

The outlet feeds the washroom and then carries on to another outlet on another floor.

Is this normal? What’s the issue? The other outlets in my house are room temperature.

Looks like it one of the gfi loads feeds two spare bedrooms ceiling fans/lights, and the other feeds an outlet in the other washroom on the main floor….this is weird, right?