Greetings! I’m working on replacing my ribbon cable and LCD screen. My pixelfix repair kit came with this little foam strip but I’m not sure what to do with it. Anyone done this repair before that can shed the light? They have a little video but it doesn’t show this strip being used.
My early M52 528i was stalling at idle and running pretty rough. I found several issues like a poorly adapted crank sensor, a couple of vacuum leaks and I replaced a lot of parts like plugs, fuel filter, ICV grommet, etc. and it's running a lot better, but one issue persists:
There is a 202 code (Lambda Regulation Bank 1 Post Cat) which points to fuel trims reaching the limits but only in bank 1. I can still hear faint popping from the exhaust so it's clear the code is right.
How can I be getting mixture problems in just one bank? I've yet to replace the pre-cat O2 sensors but they're $200 each. Most people who report mixture codes naturally see two codes, one for each bank.
I'm out of fresh ideas. Should I just keep throwing money at the problem and get the O2 sensors?
I have a 2001 BMW E39 525d, and I’m dealing with a pretty serious coolant leak.
The car loses around 1 litre of coolant overnight.
Winter is just around the corner, and temperatures are starting to drop below freezing. I have to drive the car to work early every morning, so leaving it parked isn’t exactly an easy option. I currently have about 1 litre(around 1qt) of spare coolant left, but obviously that’s not going to last forever at this rate. As you can see in the video, the coolant is dripping directly onto the belt and then running off the belt onto the ground. What would be the smartest decision in this situation? Would you keep topping it up and drive carefully until the leak can be fixed, or stop driving it altogether? Could the leak be coming from somewhere above the belt? Has anyone experienced something similar on their E39 M57? Any advice or suggestions would be greatly appreciated!
I had an engine swap done, I had a 520D and the engine and other components were taken from a 530D Touring, and I’ve noticed that the reverse lights don’t work.
Here’s what I’ve checked so far. -fuses -bulbs -transmission switch
I’ve heard that the wiring on the touring is different from the sedan, and that whoever did the swap didn’t take that into consideration when wiring it.